SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1992-1996/ 1992 Bronco/ Fixes supermotors.net/registry/28006/86473

Album section

Fixes

From 1992 Ford Bronco, documented by fodder.

36 photos
← Back to this vehicle
1992 Ford Bronco - Two gauge cluster surrounds to choose from, both broken in different places... 1992 Ford Bronco - Hot glued shroud on the aftermarket steering wheel was fun to pry apart. 1992 Ford Bronco - Crystal clear gauge cluster lens; a huge improvement over the old cracked and cloudy one. New tailgate window switch. 1992 Ford Bronco - New dash pad to replace the old cracked one. It had some velcro on it that will need paint blending. 1992 Ford Bronco - Hardtop was held down by c-clamps. Side panels had seen significantly better days. 1992 Ford Bronco - Old spark plugs weren't looking so good... 1992 Ford Bronco - Temporary tailgate latch for the spare tire carrier, to keep it from swinging around without a tire on. 1992 Ford Bronco - Old seat belt stocks and gauge cluster. 1992 Ford Bronco - Old window beltline moldings and HVAC panel. 1992 Ford Bronco - Stock steering wheel installed. Found a non-CC cover for it. Horn works now! 1992 Ford Bronco - Driver's door plungers, stock style on left, slightly different F-series one on right. 1992 Ford Bronco - Alternator bracket lower mount broken. 1992 Ford Bronco - Windshield header trim removal. Purple dots show where the metal clips are hiding in the shadows. They snap onto little round tabs on the r… 1992 Ford Bronco - Windshield header trim removal. The 4 tape marks on the top side piece show where the tabs are located (both sides are symmetric). 1992 Ford Bronco - Windshield header trim removal. Closeup showing the thin metal lip the clips hold onto. 1992 Ford Bronco - Worn brake pads with part number "NACO 405 FE-178-13-S" visible. 1992 Ford Bronco - HVAC panel temperature cable clip problems. 1992 Ford Bronco - A close-up view of the differential gears inside a vehicle's rear axle housing, lubricated with dark oil. The image shows the ring gear, pi… 1992 Ford Bronco - Close-up view of the differential gears and housing of a 1992 Ford Bronco, showing the ring gear and pinion gears coated in green fluid. 1992 Ford Bronco - Close-up view of the internal gears of a differential, likely from a 1992 Ford Bronco. The image shows the ring gear, pinion gear, and spid… 1992 Ford Bronco - Tailgate glass, passenger side, bottom of the defrost grid's vertical band is completely worn through where it rests on the inner sweep...m… 1992 Ford Bronco - Tailgate glass, drivers side, bottom of the defrost grid's vertical band is almost worn through in the same spot. 1992 Ford Bronco - Tailgate glass defrost grid, vertical bands patched up. 1992 Ford Bronco - Shortly before doing the 3G alternator upgrade, I noticed the old charge cable was dangerously exposed. 1992 Ford Bronco - Small battery tray improvement... 1992 Ford Bronco - The chrome was peeling on my original headlight bezel, so I replaced that, as well, while the battery tray was out. 1992 Ford Bronco - Finally found a transfer case skid plate (top) to replace my mangled one (bottom) that's been off the Bronco since I bought it. Unfortunate… 1992 Ford Bronco - Trimmed the front lip of the brick nose skid plate clear the cross member. 1992 Ford Bronco - Test fit of the modified brick nose skid plate. Will work fine as is, but some protection of the backside of the transfer case would be nic… 1992 Ford Bronco - Much better! I used the 3.5" strip I cut off the front, and massaged it not so gently to fill the vulnerable space in the rear. 1992 Ford Bronco - Modified brick nose skid plate mounted up, with a quick and dirty paint job. 1992 Ford Bronco - Modified brick nose skid plate mounted up. It's basically flush with the back edge of the transfer case. 1992 Ford Bronco - I was thinking of making a skirt along the base of the tailgate access panel, to redirect water back into the opening instead of pooling on… 1992 Ford Bronco - Tailgate access panel close-up, showing where water hits it on the backside. (I had previously reinstalled it upside down, so the rusty top… 1992 Ford Bronco - I then thought of filling in the ribs where they meet the tailgate openings, so a gasket could span them, then noticed it was designed with… 1992 Ford Bronco - Double-strip weatherstrip added to the tailgate side of the access panel, spanning the screw holes so they can pierce the middle and leave…