Home/ Registry/ Ford/ Bronco/ 1987-1991/ “The Beast”/ Photo supermotors.net/registry/media/204407

Hand holding an aluminum idle air control valve on a wood plank…

‹ ›

IAC SensorView all 5

Idle air control valve lying flange-up on a wood board showing two port openings

Hand holding an idle air control valve end-on, showing round solenoid face

Hand holding a used idle air control valve with two-pin connector over a plywood bench

Hand holding a used Ford idle air control valve labeled FOTE-9A over a garage floor

5photos in this albumView all

Parts and details of other 1987-1991 Broncos111,162 photos of 1987-1991 Broncos

RC car chassis with exposed wires and suspension, next to screwdrivers and a green box

rear axle and suspension parts on jack stands and a floor jack, with tools scattered around

Tie rod end with grease leaking, part of a vehicle's suspension system

Red and white side door decal on a vehicle

1991 Ford Bronco undercarriage showing suspension, differential, and part of another vehicle in background

Stick figure with gas pump nozzle, text 'ASSUME THE POSITION'

111,162photos in this generation1987-1991 Bronco

A hand holds a cast-aluminum idle air control valve against a weathered plank of wood on a garage floor, showing its two-bolt mounting flange, cylindrical air passage and dark electrical connector plug. An orange extension cord is coiled on the concrete in the background.

AI caption May 2005 · Photo 136 of 374