I ordered the front and rear Rancho's 9000X shocks. But the rear are on back ordered? Must be alot of 2wd Excursions huh? :The Rancho RS9000X part number are RS99272
Tools needed:
Jack,
15mm socket or deep socket,
Also help full are the Box/End Ratching Wrench. Also called Gear Wrench.
18 mm socket or deep socket comes very helpfull. Your local auto store also sells them individual for about 3-4 dollars each.
19mm deep socket
Wrachet
Something to stand on you you can lean over into the engine compartment.
flathead screw driver
19mm socket or deep socket comes very helpfull.
3/4th Open Box/End wrench
breaker bar or a pipe.
Grease
Adjustable torqure wrench
Drill with a wire brush on the end or a wire brush with a handle.

Adding the stroker booth is optional. I chose to add the red booth. But you must pull the booth down all the way down up to the 2 rigges where the holes are so it wont collect water. Each booth has 2 pairs of holes. have the faceing front and back so when you park on a hill or downhill (incline or what ever) they can drain. It also will be good to make a hole on both side of the booth on the first riged.

Owner caption March 2006 · Photo 75 of 190