SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Mercury/ Grand Marquis/ 1992-1997/ 1997 Mercury Grand Marquis/ Photo supermotors.net/registry/media/459494

Step 12: Remove the 2 10mm bolts that holds the thermostat ho…

Step 12: Remove the 2 10mm bolts that holds the thermostat housing in place. Remove the thermostat housing, bolts, and spacers. DO NOT REMOVE THE THERMOSTAT. This is a safety just in case some dirt or debris could get dropped into the intake and down into the water jacket inside the head.
Step 12: Remove the 2 10mm bolts that holds the thermostat housing in place. Remove the thermostat housing, bolts, and spacers. DO NOT REMOVE THE THERMOSTAT. This is a safety just in case some dirt or debris could get dropped into the intake and down into the water jacket inside the head.Original file
Step 12: Remove the 2 10mm bolts that holds the thermostat housing in place. Remove the thermostat housing, bolts, and spacers. DO NOT REMOVE THE THERMOSTAT. This is a safety just in case some dirt or debris could get dropped into the intake and down into the water jacket inside the head.

PI INTAKE SWAP(HOT!!!!)View all 42

1997 Mercury Grand Marquis photo Engine bay close-up with throttle linkage removed, EGR valve and inlet elbow V8 engine with intake manifold removed, exposing open cylinder head ports and valley Removed composite V8 intake manifold on orange cart, thermostat housing and studs visible Two composite intake manifolds set side by side on tile floor for comparison Removed black coolant tube with mounting flanges on a red picnic table Hand lifting injector wiring harness off orange-topped fuel injectors on V8 Hand holding intake manifold gasket edge-on showing molded locating tab, second gasket on bench Black plastic upper intake on aluminum lower intake with green temp sensor connector Engine bay view of V-engine front showing serpentine belt, pulleys and accessories 1997 Mercury Grand Marquis photo Composite V8 intake manifold with upper elbow removed, orange gasket around open port Aluminum upper intake elbow and throttle body with F6AE-9D475-B4A EGR disc below Aluminum upper intake elbow and Ford-marked throttle body in engine bay, top view 1997 Mercury Grand Marquis photo V6 engine front with red and blue arrows marking alternator and water pump bolts 42photos in this albumView all

Step 12:

Remove the 2 10mm bolts that holds the thermostat housing in place. Remove the thermostat housing, bolts, and spacers. DO NOT REMOVE THE THERMOSTAT. This is a safety just in case some dirt or debris could get dropped into the intake and down into the water jacket inside the head.

Owner caption · Photo 94 of 304

Is this accurate? Sign in to help verify it.

Comments

No comments yet.

More 1992-1997 Grand Marquiss

1996 Mercury Grand Marquis “The "LSE S/C"”1996 Mercury Grand Marquis “The "LSE S/C"”1,450 photos 1993 Mercury Grand Marquis “93 Marquis”1993 Mercury Grand Marquis “93 Marquis”372 photos 1993 Mercury Grand Marquis “MERC”1993 Mercury Grand Marquis “MERC”29 photos 1994 Mercury Grand Marquis “POEboy Cop Car”1994 Mercury Grand Marquis “POEboy Cop Car”72 photos 1997 Mercury Grand Marquis “SilverBullet”1997 Mercury Grand Marquis “SilverBullet”12 photos 1994 Mercury Grand Marquis1994 Mercury Grand Marquis5 photos
The 1992-1997 registry All Mercury Grand Marquiss in the registry