1967 Ford Bronco pictures, photos, videos, and sounds

The story

I originally assembled in 6 weeks for Rubicon trip in 9/2003! Only part of original drive line that wasn't replaced at that point was the transmission. Also replaced the wire harness because the old harness was butchered beyond repair by the previous owner.

Future/in process modifications:
-Ford EFI conversion

Trails conquered:
Rubicon 9/2003, 9/2004, 9/2005, 9/2006, 8/2007
Pismo 10/2003 to present!!
Fright night hungry valley ORVA 10/03 to 10/2010
Glamis 11/2003
Octillo Wells 12/31/03, 12/31/06
TDS Desert safari 1996-2012 (RIP Jim Kuns)
Truckheaven 1996-present
Dummont Dunes 4/2004, 2/2007
HIgh Desert Roundup 2004 2006 2008 2009
Armogosa sand dunes 12/2004
Bald Mountian - Moonlight Madness 7/2005, 6/2006, 6/2007
Duesy/Eirshim August 2007-2011
BBBB 2006-2011
Monache Medows & Sherman Jeep Trail June 2012

Future trips planned:

Member:

Ventura County Axlesnappers
http://www.axlesnappers.net/

SoCalBroncos
http://autos.groups.yahoo.com/group/socalbroncos/

CORVA
http://www.corva.org/

Blue Ribbon Coalition
http://www.sharetrails.org/

United Four Wheel Drive Associations
http://www.ufwda.org/

National Rifle Association
http://www.nra.org/

General class Ham Radio operator: KI6MCO — Dan Eger

Day one vs. today

Drag to compare 2003 against 2008.

2003 2008

Photo history

290 photos across 6 years — drag the dot to travel through this vehicle’s life. Captions are the owner’s; where there isn’t one, the AI caption fills in.

2003

24 photos added — showing 8

1967 Ford Bronco - Ventura county Axlesnappers on the Rubicon springs bridge 9/2002

1967 Ford Bronco - Diving down the top of big sluice 9/2002

1967 Ford Bronco - Just dropping in to the top of Big Sluce Box.

1967 Ford Bronco - My old Bronchole, RIP! I will always miss her.

1967 Ford Bronco - I hate the traffic in LA!

1967 Ford Bronco - Just airing down at the begining of the trail.

1967 Ford Bronco - Getting ready to recreate at Spyder lake.

2004

59 photos added — showing 8

1967 Ford Bronco - Two vehicles involved in an off-road incident in a desert environment.

1967 Ford Bronco - Vehicle hardtop resting on the ground outdoors, near a brick wall and utility meter.

1967 Ford Bronco - This close-up shows a gray metal panel with visible wear and tear, including scratches and chipped paint.

1967 Ford Bronco - Close-up of a gray metal panel with two holes and weld marks, placed on the ground.

1967 Ford Bronco - Close-up view of a dark gray hardtop, showing some surface wear and rust along the edge.

1967 Ford Bronco - This black metal storage box appears to be an aftermarket accessory or custom fabrication.

1967 Ford Bronco - A dark truck cap rests on the ground, showing a framed window on its side.

1967 Ford Bronco - Interior view of a vehicle showing blue quilted lining and dry brush on the floor.

2005

24 photos added — showing 8

1967 Ford Bronco - Spider camping off limits area

1967 Ford Bronco - Aerial view of terrain, possibly a natural landscape or geological formation.

1967 Ford Bronco - A person contemplates the vast landscape from a rocky peak, with distant mountains fading into the haze.

1967 Ford Bronco - Off-road enthusiasts gather at a remote fire lookout tower on a clear day.

1967 Ford Bronco - A group of off-road vehicles and a pickup truck are gathered on a dusty lot under a clear blue sky.

1967 Ford Bronco - A 1967 Ford Bronco tackles a challenging rocky trail under a clear blue sky.

2006

17 photos added — showing 8

1967 Ford Bronco - This document is a membership application form for the Ventura County Axle Snappers club.

1967 Ford Bronco - This document is a blank form for tracking truck information, including maintenance and modifications.

1967 Ford Bronco - Crap under heater air intake

1967 Ford Bronco - Thickness of crap under air intake

1967 Ford Bronco - Front end without fenders/grill. Hood/radiator supported by the old temporary supports

1967 Ford Bronco - Totter rebuild party, shock painting

2007

127 photos added — showing 8

1967 Ford Bronco - Close-up view of the undercarriage, focusing on the suspension and exhaust system components.

1967 Ford Bronco - Rear view of a 1967 Ford Bronco, showing its license plate and spare tire.

1967 Ford Bronco - A person kneels to work on the rear bumper of a modified Ford Bronco parked on a dirt road in a wooded area.

1967 Ford Bronco - Close-up view of a vehicle's undercarriage, revealing its frame and suspension components.

1967 Ford Bronco - Close-up of the undercarriage, focusing on the suspension system and exhaust components, with visible text from Supermotors.net.

1967 Ford Bronco - Undercarriage view of vehicle frame and suspension components, showing rust and wear.

1967 Ford Bronco - The image shows a close-up view of rusty metal components and a tangle of electrical wires.

1967 Ford Bronco - Close-up view of a vehicle's undercarriage, showing suspension parts and leaf springs.

2008

36 photos added — showing 8

1967 Ford Bronco - This image shows a red t-shirt graphic a cartoon beaver character holding an axle, with text identifying 'Ventura County Axle Snappers'.

1967 Ford Bronco - This photo shows a red t-shirt with white text for the Ventura County Axle Snappers Four Wheel Drive Club.

1967 Ford Bronco - This document outlines the club name, purpose, and dues for the Point Mugu Four Wheel Drive Club, dated August 2005.

1967 Ford Bronco - This document outlines membership criteria, including vehicle requirements and types, for a club.

1967 Ford Bronco - This document appears to be bylaws or club rules, with a SuperMotors.net watermark at the bottom.

1967 Ford Bronco - Page 4 of a document detailing club bylaws, meetings, and voting regulations.

1967 Ford Bronco - This document outlines club awards and executive board responsibilities, including bylaws and membership management.

Browse all 290 photos Album view

The peanut gallery

No comments yet — be the first to add to the record.

Spotted in the wild

Seen this vehicle at a show or on the trail? Add your shot — the owner approves it onto the record.

DE Dan Eger Member since 2001 · 3 vehicles

Engine: FOR SALE, Considering offers over $15,000.00

Over $5000.00 in receintly built motor:
-95 351W full roller motor
-Trickflow heads($1500 in parts)
-Fox body oil pan($150 in parts)
-Holley 4DI injection system($1100 in parts)
-Mallory billit distributer($170 in parts)
-BC Broncos ceramic coated headers($500 in parts)
-Super single - Magnaflow 2-2.25" in to 1-3"exhaust.($150 in parts)
-V6 Explorer radiator($150 in parts)
-Taurus Fan($50 in parts)
-Full custom serp belt setup. Started as Explorer serp setup and migrated from there to incorporate Mark VII Saganaw pump($300 in parts).
-Should be just under 400HP and just over 400 FtLb torque
Drivetrain: -Rebuilt 4R70W transmission
-Braumantor TCS controller ($550 in parts)
-Dana 20-T transfer case
>>Tera Low 3.15:1 gears ($830 in parts)
>>Modified/ground shift rods for true twin stick operation
>>Wild Horses HD output shaft ($430 in parts)
>>Tom's Bronco parts Twin Stick($150 in parts)
-Ford 9 inch rear axle with:
>>Strange radial ribbed econ-nodular iron case($240 in parts)
>>Detroit NASCAR locker($200 in parts)
>>Yukon alloy axles($275 in parts)
>>Dana 4.88:1 gears($180 in parts)
>>1.75 inch drum brakes($200 in parts)
>>Shaved & trussed HD housing
-Dana 44 stock EB front axle with:
>>Detroit soft locker($650 in parts)
>>Dana 4.88:1 gears($180 in parts)
>>RCV axles & joints($1400 in parts)
>>30 spline Warn locking hubs($180 in parts)
>>F150 disk knuckels($120 in parts)
>>Rolled the knuckles 13Â° to correct the caster with 0Â° (2Â° poly installed as 0Â°) C bushings
>>Extended radius arms built by me, simmilar to Lars Bars($150 in parts)
>>Balistic rod ends for raduis arms($150 in parts)
>>West Texas Off Road 1.5 inch ram assist($700 in parts)
>>4x4x2 power steering box
>>Lincoln Mark VII Saganaw power steering pump w/HP output mod
>>Bilstein 12 inch travel short body resovour 7100 shocks($500 in parts)
-Hydroboost brake system($400 in parts)
-Summit roll lock brake line locks F&R($100 in parts)
-4140 1.375 inch hex chromolly tie rod/draglink with 85 Shuvy ends($300 in parts)
-5.5 inch BC Bronco front coil springs($160 in parts)
-5.5 inch BC Bronco (Deaver) 11 leaf rear springs($450 in parts)
-Wild Horses 5/8 u-bolts and HD plates($90 in parts)
-Fiberglass cowl hood($250 in parts)
-Family roll cage ($400 in parts)
Mileage: 10,500