/ 3. 4, CARBURETOR lnspection and Adjustment (Cont'd) Adjust "L by bending the float stopper. "h": 46.5 475 mm (1.831 - 1.870 in) Float Float stopper seFa79A Install the choke chamber, and recheck the fuel level through the sight glass. AUTOMATIC CHOKE Automatic choke mechanism 1. Before starting the engine, fully open the throttle valve and ensure that the choke valve closes properlyt Push the choke valve with your finger, and check it for smooth rotation. Check to be sure that the punched index mark on the bimetal cover meets the scratched index mark on the choke housing, as shown below. Eimul can: index mark (scratch-d) tci1oka homing "1le mark (punched) sesosn 4. 1) 2) 3) 4) when the bimetal cover is removed to check the choke mechanism, install it in the following way. Close the choke valve. While setting the bimetal on the right of the bimetal lever, install the bimetal cover. Turn the bimetal cover counterclockwise to align the bimetal cover index mark and the choke housing index mark, Tighten the screws. [q : 1.5-3.9N~m (0.15 - 0.40 kgm, 1.1 - 2.9 ft<lbl [SIMBIEI simetal lover _ erhoks houslng seamen When the bimetal cover is removed and in- stalled, be sure that the punched index mark of the bimetal cover meets the scratched index mark of the choke housing. When installing the bimetal cover, make sure that the spring of the bimetal works well by pushing the choke valve. Automatic choke heater circuit Checking heater circuit with function connector CAUTION: Do not attach test leads of a circuit tester to those other than designated. 1. With engine not running, check for continuity between GY/R and B. if continuity exists, the heater is functioning properly,