BODY END AND DOOR When removing and installing hood or back door] place a cloth or other padding on hood corners to avoid scratching vehicle body. When removing clip or fastener, refer to CLIP & FASTENER. Apply sealing compound where necessary when installing parts. Front End ____r_ Hood adjustment: Adjust at hinge portion. Hood lock adjustment: After adjusting, check hood lock control operation. Apply a coat of grease to hood locks engaging mechanism. Hood opener: Do not attempt to bend cable forelbly. Doing so increases effort required to unlock hood, Front grille: lt is made of plastic, so do not use excessive force and take care to keep oil away from it, Bumper fascia: It is made of plastic, so do not use excessive force and take care to keep oil away'irom itl Bumper rubber adjustment F] 43-55 (o.44~0.56,3.z-4.1l r Cawl mp grille Hood lock adiusnlnl _ Adjust striker so that 2: is / m the center at the lock. l i : / ' " 5mm! aalusrmem f Bumner halgm H (Measure wrthm C m. _ Bumper fascia so cm [23.5 mi 7 W"- 4 E GreasE-uv mum of vehlcl: cEtEr ' " Ground V17 1 l - E Nvm (kgm. mm . on rightand ' 1th mas] primr- an l . Bumper assemblv ' Iml around i maurmng bolts a nuts Bump-r high: M: 86 -547 mm "HAS-21.54"!) i Ground W 5653755 sarzAso