1983 Ford Bronco

Lifted 1980s Ford pickup truck with large tires parked in a snowy lot. AI caption This lifted Ford Bronco is parked in a lot with snow on the ground, with a Safeway store visible in the background. AI caption A white Ford Bronco with oversized tires sits in a snowy driveway, with two vans visible in the background. AI caption This lifted 1980 Ford Bronco features a prominent grille and large off-road tires, captured in a three-quarter front view. AI caption This is before the fender flares were put on. Owner The old leaf spring and the new Procomp 6" leaf spring. Notice the old pack has a broken leaf. Owner Before the rear lift it measured almost 43" to the bottom of the fender flare. Owner After the rear lift it measured over 45.5" It went up almost 3 inches. Owner The rear lift is all done. Now it sits a little higher in the rear. Owner This is what I started out with. A $200 Bronco. Owner It was suggested to cut the bolt off on either side of the spring, between the spring and shackle. I couldn't get that to work. Kept dullin… Owner Fender flares on, but sagging in the rear. The lift used the stock wedge and a 4" block in the rear. Owner I replaced the old Edelbrock with a Holley Truck Avenger. Owner Old spring gone. Owner 4" block and stock wedge. Owner After new leaf springs. Owner Before new leaf springs. Owner The interior view shows the rear seating area of a vehicle, beige leather seats and seat belts. AI caption View from inside a vehicle, showing seats and a scene with multiple vehicles outside. AI caption A close-up view of a tire's valve stem, with a date stamp and website visible in the corner. AI caption Two tan leather car seats are shown from the front, placed on a rug. AI caption This black center console features two cup holders and a lockable compartment, likely from an older vehicle. AI caption Close-up of a metal fitting with threads and a nut, likely a plumbing or automotive part. AI caption A close-up shows a brass fitting with threaded ends and a black O-ring, held by a person's fingers. AI caption Close-up of the cargo area floor showing tie-down points and seat hardware. AI caption This image shows a ground strap and its mounting points, not a 1983 Ford Bronco. AI caption This is a close-up view of a manual transmission shifter assembly, likely for a classic car or truck. AI caption building the 302 #2 Owner Building the 302 #1 Owner Engine and tranny on hoist Owner