Blueprints — Ford Bronco 1980-1986
Technical Reference
Member-uploaded diagrams & documents for this generation. AI-classified; community-verified where badged.
Blueprints
- Dimensioned engineering drawings of axle housing flange bolt-circle patterns across several Ford axle types.
- Dimensioned blueprint of a flat mounting bracket showing 0.600 and 0.430 inch holes, 2.600 inch spacing and a 0.30 inch bent profile.
- Hand-drawn dimensioned cross-section titled 1984 Bronco Rear Cross Sill End Detail on graph paper.
- Hand-drawn dimensioned cross-section titled 1984 Bronco Rear Cross Sill End Detail on graph paper.
- Dimensioned engineering drawing of front and rear steering-box clamp sections with inner radius and hole specifications.
- Dimensioned blueprint of a gas tank skid plate showing overall measurements, 2x2 gussets, and fillet weld callouts.
- Dimensioned blueprint of a gas tank skid plate with hole and edge measurements in inches and a 0.25 steel material note.
- Dimensioned drawing of a 10-cut ignition key showing tumbler stations, cut depths in millimeters and lock set part numbers.
- Engineering fabrication drawings of pickup-box sill shims with dimensions, material/finish specs and weld instructions
- Hand-drawn dimensioned drawing on graph paper laying out a 1984 Bronco rear bed replacement panel with critical measurements.
- Hand-drawn dimensioned fabrication drawing for a 1984 Bronco rear bed replacement panel noting hole locations and 52 by 49 inch sizes.
- Hand-drawn dimensioned drawing of a sheet-metal floor panel with marked hole positions and overall measurements.
- Hand-drawn dimensioned fabrication sketch of a tailgate cross sill with measurements and welding notes.
- Rotated hand-drawn dimensioned fabrication sketch of a cross sill showing measurements and build notes.
- Hand-drawn dimensioned drawing for a 1984 Bronco rear bed replacement panel, noting 20-gauge ribbed steel and critical 49-inch and 52-inch dimensions.