1967 Ford Bronco — 290 photos

The story

I originally assembled in 6 weeks for Rubicon trip in 9/2003! Only part of original drive line that wasn't replaced at that point was the transmission. Also replaced the wire harness because the old harness was butchered beyond repair by the previous owner.

Future/in process modifications:
-Ford EFI conversion

Trails conquered:
Rubicon 9/2003, 9/2004, 9/2005, 9/2006, 8/2007
Pismo 10/2003 to present!!
Fright night hungry valley ORVA 10/03 to 10/2010
Glamis 11/2003
Octillo Wells 12/31/03, 12/31/06
TDS Desert safari 1996-2012 (RIP Jim Kuns)
Truckheaven 1996-present
Dummont Dunes 4/2004, 2/2007
HIgh Desert Roundup 2004 2006 2008 2009
Armogosa sand dunes 12/2004
Bald Mountian - Moonlight Madness 7/2005, 6/2006, 6/2007
Duesy/Eirshim August 2007-2011
BBBB 2006-2011
Monache Medows & Sherman Jeep Trail June 2012

Future trips planned:

Member:

Ventura County Axlesnappers
http://www.axlesnappers.net/

SoCalBroncos
http://autos.groups.yahoo.com/group/socalbroncos/

CORVA
http://www.corva.org/

Blue Ribbon Coalition
http://www.sharetrails.org/

United Four Wheel Drive Associations
http://www.ufwda.org/

National Rifle Association
http://www.nra.org/

General class Ham Radio operator: KI6MCO — Dan Eger

Day one vs. today

Drag to compare 2003 against 2008.

2003 2008

Photo history

290 photos across 6 years — drag the dot to travel through this vehicle’s life. Captions are the owner’s; where there isn’t one, the AI caption fills in.

2003

24 photos added — showing 8

1967 Ford Bronco — Ventura county Axlesnappers on the Rubicon springs bridge 9/2002

1967 Ford Bronco — Diving down the top of big sluice 9/2002

1967 Ford Bronco — Just dropping in to the top of Big Sluce Box.

1967 Ford Bronco — My old Bronchole, RIP! I will always miss her.

1967 Ford Bronco — I hate the traffic in LA!

1967 Ford Bronco — Just airing down at the begining of the trail.

1967 Ford Bronco — Getting ready to recreate at Spyder lake.

2004

59 photos added — showing 8

Lifted dark Ford Bronco climbing over an overturned maroon sedan in the desert

Hardtop for a vehicle, possibly a Bronco, sitting on the ground

close-up of a gray metal panel with scratches and chipped paint

Gray metal panel with two holes and visible welds, resting on dirt

Black metal storage box with textured panel on the side

Truck cap with a dark window panel, sitting on the ground outdoors

1967 Ford Bronco — Vehicle interior with blue quilted lining and dry brush on the floor

2005

24 photos added — showing 8

1967 Ford Bronco — Spider camping off limits area

Rocky, uneven ground with sparse vegetation and a dark shadow. Watermark reads SUPERMOTORS.NET

Person sits on a rocky summit with trees, overlooking a hazy blue valley

1967 Ford Bronco — Two off-road vehicles parked on a rocky overlook near a fire lookout tower with people on it

1967 Ford Bronco — White pickup truck with a camper shell parked next to several off-road vehicles on a dirt lot

White 1967 Ford Bronco navigating rocky terrain

2006

17 photos added — showing 8

Blank Ventura County Axle Snappers club membership form

1967 Ford Bronco — Blank Ventura County Axle Snappers membership form page titled Truck Info with empty modification table

1967 Ford Bronco — Crap under heater air intake

1967 Ford Bronco — Thickness of crap under air intake

1967 Ford Bronco — Front end without fenders/grill. Hood/radiator supported by the old temporary supports

1967 Ford Bronco — Totter rebuild party, shock painting

2007

127 photos added — showing 8

1967 Ford Bronco — Vehicle underbody showing leaf spring and exhaust pipe

1967 Ford Bronco rear view with California license plate 4EHM670 and spare tire mounted externally

Man works on rear of a lifted Ford Bronco with spare tire and gear in the back. License plate reads 4EH

1967 Ford Bronco — Undercarriage of a vehicle showing rusty frame, leaf spring, and fuel line

1967 Ford Bronco — Undercarriage view of vehicle suspension with leaf springs and exhaust pipe

Close-up of rusty vehicle frame with leaf springs and suspension parts visible

Close-up of rusty metal brackets with blue and white electrical wires bundled behind them

1967 Ford Bronco — Undercarriage of a vehicle with leaf springs and suspension components visible

2008

36 photos added — showing 8

Red t-shirt with beaver holding broken axle, 'Ventura County Axle Snappers'

Red T-shirt with white Ventura County Axle Snappers Four Wheel Drive Club print

Ventura County Axle Snappers club jacket embroidery sample with cartoon gopher breaking an axle

Club by-laws document from August 2005 for Point Mugu Four Wheel Drive Club

Document titled "ARTICLE IV - MEMBERSHIP" with club requirements and types

Document page with text about club bylaws and voting regulations

Page 5 of club bylaws detailing awards and responsibilities

Browse all 290 photos

See every Ford Bronco in the registry The 1966–1977 Ford Bronco registry

The peanut gallery

No comments yet — be the first to add to the record.

Spotted in the wild

Seen this vehicle at a show or on the trail? Add your shot — the owner approves it onto the record.

DE Dan Eger Member since 2001 · 3 vehicles

Engine: FOR SALE, Considering offers over $15,000.00

Over $5000.00 in receintly built motor:
-95 351W full roller motor
-Trickflow heads($1500 in parts)
-Fox body oil pan($150 in parts)
-Holley 4DI injection system($1100 in parts)
-Mallory billit distributer($170 in parts)
-BC Broncos ceramic coated headers($500 in parts)
-Super single - Magnaflow 2-2.25" in to 1-3"exhaust.($150 in parts)
-V6 Explorer radiator($150 in parts)
-Taurus Fan($50 in parts)
-Full custom serp belt setup. Started as Explorer serp setup and migrated from there to incorporate Mark VII Saganaw pump($300 in parts).
-Should be just under 400HP and just over 400 FtLb torque
Drivetrain: -Rebuilt 4R70W transmission
-Braumantor TCS controller ($550 in parts)
-Dana 20-T transfer case
>>Tera Low 3.15:1 gears ($830 in parts)
>>Modified/ground shift rods for true twin stick operation
>>Wild Horses HD output shaft ($430 in parts)
>>Tom's Bronco parts Twin Stick($150 in parts)
-Ford 9 inch rear axle with:
>>Strange radial ribbed econ-nodular iron case($240 in parts)
>>Detroit NASCAR locker($200 in parts)
>>Yukon alloy axles($275 in parts)
>>Dana 4.88:1 gears($180 in parts)
>>1.75 inch drum brakes($200 in parts)
>>Shaved & trussed HD housing
-Dana 44 stock EB front axle with:
>>Detroit soft locker($650 in parts)
>>Dana 4.88:1 gears($180 in parts)
>>RCV axles & joints($1400 in parts)
>>30 spline Warn locking hubs($180 in parts)
>>F150 disk knuckels($120 in parts)
>>Rolled the knuckles 13Â° to correct the caster with 0Â° (2Â° poly installed as 0Â°) C bushings
>>Extended radius arms built by me, simmilar to Lars Bars($150 in parts)
>>Balistic rod ends for raduis arms($150 in parts)
>>West Texas Off Road 1.5 inch ram assist($700 in parts)
>>4x4x2 power steering box
>>Lincoln Mark VII Saganaw power steering pump w/HP output mod
>>Bilstein 12 inch travel short body resovour 7100 shocks($500 in parts)
-Hydroboost brake system($400 in parts)
-Summit roll lock brake line locks F&R($100 in parts)
-4140 1.375 inch hex chromolly tie rod/draglink with 85 Shuvy ends($300 in parts)
-5.5 inch BC Bronco front coil springs($160 in parts)
-5.5 inch BC Bronco (Deaver) 11 leaf rear springs($450 in parts)
-Wild Horses 5/8 u-bolts and HD plates($90 in parts)
-Fiberglass cowl hood($250 in parts)
-Family roll cage ($400 in parts)
Mileage: 10,500