1995 Ford Bronco

Mock up of new E4OD Crossmember Owner Before welding.....Cost of steel was $37.08 Owner Various rusty automotive brake and suspension components are spread out on a wooden surface. AI caption 1977 Dana 44 out of F-150. Bought it at a Swap meet for $150....1/2" thick tube walls!!! Owner Painted with POR-15 and Chassis coat black Owner A close-up view of a black rear axle assembly supported by an orange jack stand in a cluttered garage setting. AI caption Painted parts...(POR-15) Owner Sandblasted parts... Owner After I striped down the axle I had it hot tanked at a local Machine shop for $20 (well worth it IMO). Then I hit it with a wire wheel and… Owner Since I am going to swap discs into the rear using 76-79 F250 front 4x4 brakes (with big dual piston calipers). I had to find the correct b… Owner Chevy 8-lug parts for sale Owner 1978/79 K20 Chevy Calipers (good cores) Owner Big Bearing Chevy Spindles (in great shape) Owner Good bearing surfaces (no damage at all). Owner Two wheel hubs are shown, one with a black finish and the other with rust on its flange. AI caption Good bearing surfaces. Owner Chevy 8-lug caliper brackets (aka backing plates). In good shape, no rust. Were sandblasted and painted with POR-15. Owner Chevy inner shafts. Owner Long inner measures about 35.5" Owner Short inner measures about 19" Owner Dana 44 1/2 ton Ford hubs and rotors. Rotors would need replacing, but hubs are fine, just need a little cleaning up. Owner Dana 44 Ford 1/2 ton calipers. Good cores. Owner Chevy 8 lug hubs out of 78/79 K20. In great condition. Were sandblasted and painted with POR-15 Owner