got the flooring in and trimmed. the firewall edge needed a good amount trimmed and some along the driver side. the passenger side was fine and the back needed only some of the corners trimmed. my transfer case shifter needed to be cut out but was not too hard.

i used a pick to find the holes for the seat, seatbelts, center console pushed up from the bottom of the truck. i started in the center console area using the 3 mounting bolts to keep it from moving, then worked to the sides, then the front and finally the back.

the floor molded pretty well to the floorpan with only a couple very minor issues. some areas are abit loose, maybe some spray on adhesive would help with that. but for the most part its good as it is

Owner caption December 2018 · Photo 277 of 426