assem' 22. If transmission case, output shaft, tapered roller bearing or front cover is replaced, output shaft should be adjusted by means of shims. 1) Lubricate bearing outer race. 2) Press bearing outer race into converter housing. 3) Install two or three shims on front cover, and press bearing outer race into front cover. 511340000! 26032) SATJSO 4) Install gasket and front cover on converter housing. 5) Measure output shaft preload. Specified output shaft bearing preload: 0.15 - 0.32 N-m (1.5 - 3.3 kgvcm, 1.3 - 2.9 in-lbl 5. Turn output shaft at least 10 times before measuring output shaft bearing preload. b. Ensure that output shaft turns smoothly with- out binding. c. If any abnormalities are noted in b. above, or output shaft bearing preload is outside specified range, disassemble and reassemble SAYIISZ Available shims: Refer to S.D.S. 23. Adjust idler bearing preload as follows. 1) Clean threads of bolts and converter housing with solvent. 2) Apply locking sealer to threads of bolts and install them into place. 3) lnstall lock washer and idler gear bolt, and tighten bolt to specified torque. Be sure to align lock washer with groove on conver- tor housing. Ylmwrlrlly Iihhn Mas . as N-m (2.7 - 11 km, 20 . 27 mm sAtasJ 4) After tightening bolt, turn output shaft five complete rotations. Loosen idler gear bolt, then tighten it to specified torque. 5) Bend lock washer. Luck washer SATasd 6) Turn output shaft to make sure it operates smoothly.