Home/
Registry/
Ford/
Bronco/
1966-1977/
1974 Ford Bronco/
Photo
supermotors.net/registry/media/306933
Page 46 of a maintenance manual detailing vehicle care and cooli…
This document page covers brake fluid, gas tank, and power steering fluid checks, plus cooling system refill instructions.
46 Maintenance VEHICLE CARE (Cunnnuedl Brake Fluid Tu check the brake fluid level. wipe on the master cylinder cum and [dense are winning clip. Remove me cover and seal. Do not nllow any cumammzuun lu [all inlu (III: mum brake cylinder Always man-lulu the uid level nl the maximum lull level (1/4" [ruin llse lap of th: brnlre mmer cylinder} If the uid ls lnw, add Ford Heavy-Duly Brake Fluid C6AZ-lBS42-A or is uid meelmg Furrl Spacicatmn Es M6C25A ar DOT-3. CAUTION , An lhnnxmllly law level of brake uid my indium s Ink in lh: nuke syslzm. The lmke lines Ind eylmden slsnuld be inspected m delesmine the ux. Keep the Gas Tank Full A full gm lnnls nvpuls the condensation of mcislure on use inside walls ol the tank; and reduces thl. posubuuy or water m the fuel unes. 'lry to keep me tank as lull as you mmanicnlly can. Power S1uing Fluid To Lilac: {he power sleerlng uid, have lht engine at (menus-l5 lumpemum [.51 use engine run at idle while you rurn lne wheels left and right scvcral limes to get any alx mu cl Lhc sleering syslenp Then stop the engine and observe the fluid level ml me dipxliuk. It rnurl be rruinlaincrl between (In: FULL HOT nrmw and the end at the Slick. Do not uvnrfill the system. Refer to [he Lubrication Chm! [page 54) fur the proper uid Io um Cooling Sysrem Refill After draining the cooling syslem, [he Fallnwlng nfill procedure should be used to remave a): from the system and pruvsde proper wollnl level. Wimnl Caulnnl Recrwery - Place heme! lempernlure conlrol at maximum heat (WARM) positiun. e Fill radiator to one Inch below the radium opening (n cylinder Engines). Leave rndinlur can on. - Operate the engine until thexmoslal opens and mdmtm upper nose becomm hat 0 Stop engine and nail unalnnt to bring level lo one inch below
Is this accurate? Sign in to help verify it.
No comments yet.