MANUAL STEERING GEAR AND LINKAGE R22T Assembly and Adjustment (Cont'd) 9) If pinion rotating torque is out of specificav tions, readjust it. TIE-ROD AND BOOT it Apply locking sealer to threaded portion of tie~ rod inner socket and fit it to rack end. Secure tie-rod inner socket to rack end with pin. SSTSSEA 0 Do not stick pin out of rack outer diameter. I 2, Install boot on tie-rod inner socket. SSTSSOA 3, Install lock nut and tie-rod outer socket to inner socket. Adjust tie-rod length "L" and tighten lock nut. Tierod length L": 107.1 mm (4.22 In) 'ssTsmA 4 Measure rack stroke. Measure length "i2": 66.7 mm (2.626 in) N 71L E ii We Elm 1 LL HH k ll ssrsszA 5. Install boot clamps 0 To install, wrap boot clamp around boot groove twicer Tighten clamp by Misting rings at both ends four or four and one-half turns with screwdriver while pulling with a force of approx. 98 N (10 kg, 22 lb). as N ilukg, am 340 mm A ll: 39 ml 7 ssraasA