File 261 of 266
Prev | Next

bumperf92.jpg | Hits: 138 | Posted on: 6/23/08 | View original size (234.87 KB)

'92-97 Front Bumpers

1 Front Bumper 17757
2 Nut N804525-S59
3 Frame (Side Rail) 5005
4 Bumper Isolator and Bracket Spacer 17765
5 Rivet (12 Req'd) 388442-S309
6 Front License Plate Mounting Bracket 17A385
7 Rivet (3 Req'd) N803043-S
8 Front Valance Panel 17626
9 Front Bumper Horizontal Pad 17C829
10 Arm, Front Bumper 17766 (RH); 17767 (LH)
11 U-Nut N800296-S301
12 Screw and Washer N606689-S301
13 Reinforcement, Front Bumper, Bronco Only 17859 (RH); 17C863 (LH)
14 Bolt (4 Req'd) N605934-S53
A - Tighten to 60-80 N-m (44-59 Lb-Ft)
B - Tighten to 19-25 N-m (14-18 Lb-Ft)

Removal
1. Support the bumper assembly and remove the four nuts (two each side) attaching the assembly to the frame mounting brackets.
2. Carefully lower the bumper assembly from vehicle and lay it on a protective surface.
3. If replacing bumper bar, remove front bumper horizontal pads (17C829), front fender apron and radiator support braces (16A023) or front license plate mounting bracket (17A386).

Installation
1. If bumper bar was replaced, install front bumper horizontal pads, front fender apron and radiator support braces or front license plate mounting bracket. Refer to «Bumper Bar» in the Removal and Installation portion of this section.
2. Align bumper assembly mounting studs to the holes in the frame mounting brackets.
3. Insert studs through slot in frame brackets. Loosely assemble nuts to hold front bumper (17757) to frame (5005) (side rail).
4. Align front bumper to front fenders (16005) and sheet metal stone deflector maintaining a parallel margin of 18-31mm (.76-1.24 inch). If rotation is an issue, use shim as required.
5. After front bumper is aligned, tighten nuts to 60-80 N-m (44-59 lb-ft).