SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ F-150/ 1992–1996/ “Ol' Blue”/ Mine again supermotors.net/registry/23144/88029

Album section

Mine again

From 1995 Ford F-150 “Ol' Blue” — documented by Steve83.

29 photos
← Back to this vehicle
1995 Ford F-150 - After a decade, it's back at about 180Kmi. And it needs a lot of work... The Bronco is still doing well, despite chewing up some transfer c… 1995 Ford F-150 - It had been parked for a few months on rural property, so job 1 was to remove the rat nests. I took out all the interior except the dash (a… 1995 Ford F-150 - It had been parked for a few months on rural property, so job 1 was to remove the rat nests. I took out all the interior except the dash, a… 1995 Ford F-150 - It had been parked for a few months on rural property, so job 1 was to remove the rat nests. I took out all the interior except the dash, a… 1995 Ford F-150 - The original floor pad was chewed & filthy, so I burned it, and replaced it with Peel & Seal (same as DynaMat Xtreme). 1995 Ford F-150 - Somehow, the fin for the driver's door seal rusted away, so I replaced it & sealed the hole in the floor. I couldn't find the paint I bough… 1995 Ford F-150 - I really like this charging cradle , but I hate that it only mounts by suction. So I built a base that fits the dash better. The arm pivots… 1995 Ford F-150 - The original headlights have been foggy for years, and direct replacements are no better or more-durable. So I put in these DOT-legal proje… 1995 Ford F-150 - The mirror & radio are re-recycled from the totalled '94 CV. 1995 Ford F-150 - The 2KW inverter is wired to the battery positive via a 175A Mega fuse and two 8ga wires. It has 4 USB jacks, and low & hi voltmeters. Late… 1995 Ford F-150 - This dual USB jack has a 12V meter, and is wired to a key-switched circuit, which also powers 4 more USB power sockets inside the dash for… 1995 Ford F-150 - I moved the original PSOM into this tachometer cluster; I converted the oil pressure gauge to work; I switched the buzzer to a chime; and I… 1995 Ford F-150 - This cheapo shifter knob almost matches the exterior color, and cost a lot less than an OE knob would have, if I could have found one. It i… 1995 Ford F-150 - Fuel Cap Tether grommets are all degraded by now, and I haven't found replacements for them. But I was able to find a different-style tethe… 1995 Ford F-150 - In preparation for hauling a ~440# spool of cable-distribution coax, I added some Explorer tiedowns to the bed fore & aft of the wheelwell.… 1995 Ford F-150 - This kit was just over $6 shipped, and it's amazing how much quieter & smoother the tailgate works now. IF THE IMAGE IS TOO SMALL, click it… 1995 Ford F-150 - I was hesitant to try "universal" parts when I know that fitted ones (88068 ) were once made; but those are getting rare & expens… 1995 Ford F-150 - Now I can vent the truck without letting rain in. AVS VentShades 12068 stainless screw AVS VentShades 12688 stainless tape AVS VentShades 3… 1995 Ford F-150 - Fabricated engine mounts have been available for smallblock V8s for years, but not for 4.9Ls, which are just as likely (if not moreso) to b… 1995 Ford F-150 - Saginaw PS Pump Swap After finding a few Saginaw setups on a junkyard run, I cleaned up all their parts and put one on this truck. I also s… 1995 Ford F-150 - Saginaw PS Pump Swapped After finding a few Saginaw setups on a junkyard run, I cleaned up all their parts and put one on this truck. I als… 1995 Ford F-150 - I don't remember how this Draw-Tite 75038 ended up in my junkpile, but it fits. A Curt 13310 might be better, and it's made in USA. 1995 Ford F-150 - These OLED license lamps will stay brighter longer. IF THE IMAGE IS TOO SMALL, click it. The brake lights are also LED, which requires this… 1995 Ford F-150 - The boots are shot, but the tie rod ends are still tight & smooth, so I swapped on some Energy 9.13101G polyurethane boots, and then grease… 1995 Ford F-150 - While doing some other work, I noticed the RHF wheel was VERY loose. It turns out the lower ball joint was installed with the wrong nut (ca… 1995 Ford F-150 - I drove the F150 to buy a used F250 because I knew it would be easy to remove the front bumper & pull the F150 home behind the F250 using a… 1995 Ford F-150 - It isn't 4WD, or built for hauling, but this little truck has become my go-to for picking up burnable yard waste from my 10 acres because i… 1995 Ford F-150 - Like my other trucks, I added TPMS to this one. It has already been useful & worthwhile several times. 1995 Ford F-150 - The the engine began stalling on the rear tank at progressively higher indicated fuel levels. At first, I thought it was a [url=https://www…