bearing, differential case or converter housing is replaced, final drive should be adjusted. Preload is adjusted by selecting shims of appropriate thick Type A 1, Remove left side bearing inner race and shim(s) from bearing retainer. Drift 1 2. Place Tool and the following parts in trans mission case. [Jr/ Len Sid! bearing inner race 33200-83, 5, 7 g A l: PUM sATsso Gasket must be installed on transmission case. 3. Position four spacers so they are evenly spaced around transmission case and install converter housing. Then tighten bolts alternately to the specified torque. M : 14 N-m (1.4 kg-m,10 ft-Ib) 4. Rotate final drive assembly a few times to ensure proper seating. Using a feeler gauge, measure the widest gap G around Tool, AT-41 , _lf,transmission_case,;beatingre.tainer,,taperedmller_ ., lished. US$200 Select shim with proper thickness, using 5.0.5. as a guide. Available shims: Refer to 5.0.5. Remove bearing retainer from transmission case. Install shim selected in step 6 on bearing retainer and bearing inner race into it. Lubricate O-ring and install it on hearing retainer.