Type A (Cont'd) 10, Install bearing retainer to transmission case. 1- 11. Attach converter housing and gasket to trans- mission case. Tighten bolts to the same torque in a crisscross fashion. 12. Measure diff. side bearing preload with KV38105900. 2. KVSBIOSQUO 33201) SATSBS Specified dit side bearing preload: 2.9 - 4.4 N-m (30 - 45 kgcm, 26 - 39 in-lb) Turn final drive assembly at least 10 times before measuring diff. side bearing preload b. Changes in diff. side bearing preload per revolution should be within 1.0 N-m (10 kg-cm, 8.7 in-lb) without binding. If any abnormalities are noted in b. above, or diff. side bearing preload is outside specified range, disassemble and reassemble again. D. 13. Disassemble transmission case and remove final drive assembly. AT-42 Remove bearing inner race on shim side only and take out shim. We Suitable arm Tool 1 " - \ r1 7 /, /% ,//, / ///.//// Shim l sAuss Press fit bearing inner race into place without shim. Suitable drl SATIES Install final drive assembly on transmission case. Place gasket on transmission case, then install 7 converter housing. 1;, Tighten bolts to the same torque in a crisscross fashion. Attach dial gauge using Tool KV38106000. If clamp diameter of dial gauge is too sma" or too large, attach dial gauge to Tool KV38106000 using a magnetic stand.