Welded box-frame joint clamped with C-clamps showing fresh weld…

Custom steel winch bumper being fabricated and welded onto a vehicle frame. Date stamp reads 11/09/2005 Front of a vehicle with a custom metal winch bumper being installed over the existing bumper area. Radiator an Metal frame pieces attached to a vehicle's front end, with a radiator visible behind. A hand is holding a piec Winch mechanism with red hoses and electrical components, resting on rusty metal Winch roller fairlead on a metal plate, with leaves on the ground. A red toolbox is to the left Welded steel frame rail section with bracket plates lying on a concrete garage floor Rusty steel frame section with welded plate, two bolts with hex nuts, and a spliced seam; dated 12/29/2005 Welded box-frame joint clamped with C-clamps showing fresh weld beads and bolt holes Welded steel frame crossmember with bracket and bolts on a concrete floor Close-up of welded steel bumper fabrication with roller pin, bolts, and stitch welds, dated 12/29/2005 Welded steel roller fairlead mounted to flat steel plate on garage floor, dated 12/29/2005 Welded steel winch mount bracket with hex bolts and weld bead on garage floor Electric motor and red spool assembly bolted between steel rails on garage floor, small tire nearby, dated 12/ Black Ramsey winch clutch/gear housing cover held in hand in a workshop 1985 Ford Bronco photo Orange winch mounted in front frame crossmember behind radiator, dated 01/03/2006 32photos in this albumView all