After rough-bending some scrap metal into shape, test-fit it & adjust it a few times. Then scuff all the surfaces for the adhesive, and lay it on. Don't be shy - the excess will squirt out, but voids will cause future problems. I'm using JB-Kwik because it's cheaper & probably stronger than normal panel adhesive, and doesn't require an expensive applicator gun & tips. I'm mixing it with old popsicle sticks in the bottom of a Sprite can. But it doesn't allow much working time (only mix for ONE reinforcement at a time), so standard JBWeld or panel adhesive is probably better.

Owner caption May 2012 · Photo 4486 of 5000