Put the axle shaft back in. Put on a new spindle seal. For the p…

Put the axle shaft back in. Put on a new spindle seal. For the passenger side, make sure the shaft goes back into the slipyoke correctly. Might have to clean the splines for the yoke and put some grease on them.

If the u-joint on the shaft does not go through the hole of the knuckle, you will have to grind down the edges of the u-joint caps. i had to on mine but its not always nessecary. even the factory u-joint caps have alittle of the edges down. dont grind too far where you go throughthe cap tho.

Owner caption July 2012 · Photo 25 of 378