01CVCluster.JPG
905 hits | 52.69 KB | Posted: 7/4/06
'92-up Crown Vic clusters (and probably MANY others) have a factory "anti-slosh module" inserted in ...

02AntiSlosh.JPG
880 hits | 54.29 KB | Posted: 7/4/06
Removing the module is simple - just press the lock in the center & slide it straight out. The wipe...

03TruckCluster.JPG
696 hits | 89.19 KB | Posted: 7/4/06
Although no truck was built with an anti-slosh module installed, their clusters were designed for it...

04SloshSlot.jpg
745 hits | 92.1 KB | Posted: 7/4/06
The truck cluster is ready to have the module with only 2 modifications:
1) the sender loop, which ...

05LevelLoop.jpg
566 hits | 65.42 KB | Posted: 7/4/06
Cut the loop open so the traces are even with the rest of the flap.

06TraceMissing.jpg
587 hits | 71.58 KB | Posted: 7/4/06
This is how it should look. Note that the wiper near "R3" on the PC board is the output for the lig...

07SloshIn.jpg
698 hits | 73.58 KB | Posted: 7/4/06
The module slides down & locks in place.

The power feed for the module comes out to the lower L t...

SwitchLED.jpg
400 hits | 65.81 KB | Posted: 3/17/07
This LED switch is about $3 at Wal-Mart and it's built with the correct resistor (inside the heat-sh...

08GaugeBack.jpg
616 hits | 52.75 KB | Posted: 7/4/06
The light can be placed anywhere you like. I chose the lower L end of the fuel level scale on the g...

09GaugeFront.JPG
719 hits | 62.35 KB | Posted: 7/4/06
It almost looks stock. To reduce the amount of light going in from the front, I used a black perman...

10Wire.JPG
543 hits | 83.9 KB | Posted: 7/4/06
With its tip tinned & flattened, the wire pushes into the uppermost wiper terminal on the module eas...

12Done.JPG
601 hits | 72.57 KB | Posted: 7/4/06
The cluster is ready to install, without any modification to the rest of the truck. If it ever gets...

LFL_Off.JPG
557 hits | 72.05 KB | Posted: 9/20/06
When off, the black marker on the surface helps it blend with the gauge face.

LFL_On.JPG
734 hits | 65.45 KB | Posted: 9/20/06
When on, the light is hard to miss, but not too distracting.

ClusterLFL_On.JPG
683 hits | 47.81 KB | Posted: 9/20/06
When on, the light is hard to miss, but not too distracting.

The 7 gold screws (7/32" or 5.5mm he...

Cluster97HD.JPG
518 hits | 46.11 KB | Posted: 10/12/06
97 HD Cluster

Note the lack of a resistor for the oil pressure gauge. This cluster cannot be mod...