Window Motor Repair
IF THE IMAGE IS TOO SMALL, click it.

After removing the door panel, locate the dimples over the motor bolts, and drill them ~1/2" (just larger than your 5/16" magnetic driver) so the motor can be removed from the door. Remove the cover screw, open the crimps, pop the cover off, clean out the delrin residue, and remove the snap ring & washer from the shaft so the metal gear can be lifted enough to slip the 3 1/4" nuts into the wells of the large plastic gear.

See also:
.

Owner caption April 2024 · Photo 0 of 5000