SuperMotors SuperMotors SUPERMOTORS Search: try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1987–1991/ “OJ Mobile”/ Project Revive supermotors.net/registry/24918/87212

Album section

Project Revive

From 1988 Ford Bronco “OJ Mobile”, documented by Kingfish999.

22 photos
← Back to this vehicle
1988 Ford Bronco - so after 2.5 years of hiatus from Project Possessed which never got done, i figured it finally time to get this ol truck back in business.… 1988 Ford Bronco - i recently made a set of 37 inch military wheels re-centered for the correct offset. they are Goodyear MT and have the runflats replaced wi… 1988 Ford Bronco - plenty of clearance in rear with the 37" wheels 1988 Ford Bronco - there is no weight in the front due to the engine and tranny being out so once there in, the front will be quite lower due to the soft Deav… 1988 Ford Bronco - Dana 50 third member regeared for 5.13 ratio and Grizzly locker installed 1988 Ford Bronco - dropping the engine in. had to pull the truck from its resting spot onto cement then take the front tires off to get it to go over.. once i… 1988 Ford Bronco - engine dropped in. ready to be assembled. 1988 Ford Bronco - because the engine went in soo well, we decided we should go ahead and get the tranny and t-case in. using my neighbors motorcycle jack i w… 1988 Ford Bronco - moved the truck to cement for easier working on. also washed it and cleaned alot of old mud out 1988 Ford Bronco - new headlights installed 1988 Ford Bronco - transmission crossmemeber relocated for the E4OD and modified a universal body mount bushing to to use as a transmission mount 1988 Ford Bronco - i decided to replace the coil buckets with a set of James Duff coil buckets i had from my old 96. i have them located as forward on the fra… 1988 Ford Bronco - rear Dana 60 semi-floating axle regeared for 5.13 ratio and welded locked. due to the rear axle being an uncommon Dana 60 c-clip axle, the… 1988 Ford Bronco - the tailgate was completly falling apart at the seams and rusting baddly due to the window opening. the window linkage was completely ruste… 1988 Ford Bronco - inside lip of the diamond plate. its recessed at the handle so you wont get cut opening the tailage 1988 Ford Bronco - because the truck is using a 92-96 harness, there are unused running lights used in the 87-91. i used these to wire up LED pods for extra l… 1988 Ford Bronco - just like my 96, i am going to bedline the floor and put vinyl flooring over it. i did not use the sound insulation. i also had new seats t… 1988 Ford Bronco - vinyl flooring put in. same kit i used for the 96. its made by Auto Custom Carpet and i got it from Automotive Interiors for cheaper than a… 1988 Ford Bronco - vinyl flooring passenger side view 1988 Ford Bronco - new seats from a ~2000s Chevy (probably Silverado). looked through the junkyard for the best pair of seats i could that were not cloth. the… 1988 Ford Bronco - because the seats came from a chevy with a pretty flat floor, but the floor of a ford has the seating area raised up, i had to fabriate a l… 1988 Ford Bronco - an idea what the dash we made looks like. the dash is made from PVC board and is very nice and easy, waterproof and cheap but it apparently…