Bronco rear with hardtop removed and gray-primered tailgate pane…

The previous owner rear-ended this '96 XLT Sport, and installed a replacement t/g with a trim panel. The new owner wants it to look right (no trim panel), so he bought this new t/g shell without trim panel holes for me to install. It's marketed for '83-93 because it has large latches ('83-96) and no carpet holes (except '94-96), so I'll drill holes for the carpet pushpins. I'm also adding my right-side reinforcement, and undercoating the bottom seam so it won't fill with dirt, salt, & water.

Camper glass run
Heated glass
Inner & outer weatherbelts
Rubber end seals
Inside release handle
Support cables
Glass brackets & regulator channels
Window motor
Motor drive gear & bushings
Bolts (regulator, runs, & torsion clamps)
Regulator (all new regulators are LOW QUALITY - not recommended)
T/g run felts
Bolts (torsion loop)
Pushpins (carpet & camper trim)

Owner caption April 2014 · Photo 5100 of 6546