After rotating the spring plates, I became very conscious of rattles from the chassis. One of the worst was the Y-pipe (which had been cut in several places & then welded back together) resting on the transmission crossmember. I didn't have time to make a hanger, so I just slipped a rubber pad & Aluminum shield plate under it temporarily.
IF THE IMAGE IS TOO SMALL, click it.
.
I hadn't noticed the transfer case vent lying on the skidplate until I saw this pic.
![04yxmbr.jpg After rotating the spring plates, I became very conscious of rattles from the chassis. One of the worst was the Y-pipe (which had been cut in several places & then welded back together) resting on the transmission crossmember. I didn't have time to make a hanger, so I just slipped a rubber pad & Aluminum shield plate under it temporarily.
IF THE IMAGE IS TOO SMALL, click it.
[url=https://www.supermotors.net/registry/media/1161542][img]https://www.supermotors.net/getfile/1161542/thumbnail/06springplates.jpg[/img][/url] . [url=https://www.supermotors.net/registry/media/1072137][img]https://www.supermotors.net/getfile/1072137/thumbnail/08muffler15y.jpg[/img][/url]
I hadn't noticed the transfer case vent lying on the skidplate until I saw this pic.](https://www.supermotors.net/getfile/1161567/fullsize/04yxmbr.jpg)