7. Install adjusting cap and align any of its slots with hole in spindle. If necessary. tighten lock nut as much as 15 degrees until the hole in spindle is aligned with any slot. CAUTION: Do not overtighten wheel bearing nuts, as this an cause wheel bearing seizure. 8, Turn the hub in both directions two or three times measuring if its turning torque and axial play are within the following ranges. Adjust if necessary. Axial play: 0 mm (0 in) Wheel bearing starting torque: With a new grease seal 0.29 - 0.93 N-m (3.0 - 9.5 kgcm, 2.6 - 8.2 in-lh) or less When measured at the wheel huh bolt 5.9 18.6 N {0.6 - 1.9 kg, 1.3 - 4.2 lb) or less With a used grease seal 0.29 - 0.93 N-m (3.0 - 9.5 kg-cm, 2.6 ~ 8.2 in-lbl or less when measured at the wheel hub bolt 5.9 - 18.6 N (0.6 >13 kg, 1.3 - 4.2 lb) or less smmis 'greload Adjustment (Eantfdl 9. Correctly measure rotation starting force r; toward tangential direction against hub bolt. . Above figures do not include "dragging" resis , tance. When measuring wheel bearing starting torque, be sure to confirm no "dragging" resistance exists, Any slightest wheel bearing axial play cannot be tolerated, 10. Spread cotter pin. 5RAA17 RA~4