Take off the 5 or 6 spindle nuts. to make everything easier i used a slide hammer and spindle puller setup. 3 hits had the spindle off in less than 10 seconds and no damage to anything

I had 4WABS on this truck but from a previous time taking the spindle off, i already had the sensor off (nottice the hole). Getting the sensor off is a PITA. if i remeber it uses a 12-point 6mm or 5.5mm bolt, not sure. Either way the bolt never comes out and almost always has to be broken off. I never likes ABS so i never bothered spending the money to get it fixed. Taking out this sensor will make the ABS light come on and no longerwork.

Owner caption July 2012 · Photo 9 of 386