42-04-3 Front Door thdow Glass and Mechantsms 42-04 RUNNER WEATHEHSTRIP ASSEMBLY 20545 WINDOW RUN A 12,548 ADHEswE / v \ scREvy RETAINER a A 5592 RETAINER ASSEMBLV SEALER ASSEMBLv VENT WINDOW DIVISION BAR ELASOS WINDOW RUN VENT WINDOW 21550 I) 121548 21402 M CHANNEL ASSEMBLY TAPE 35335 VIEWD WEATHERSTRIP AND ADHESIVE WINDOW 205... Mr T P 335I85 , , / REGULATOR @ l REAR RUN ASSEMBLY LOWER CHANNEL 23200 RETAINER ASEEZIEBSLY ASSEMBLY REGULATOR l RETAINER 21532 ASSEMBLY \AND BRACKET 23200 ASSEMBLV \__223 C) SCREW 0 I 57471 SCREW > WlNFzgngBFIUN . 57471 WINDOW 7711 FT-LES 241 DOOR ASSEMBLY INNER PANEL SCREW 5747, WEATHERSTHIP FIG. 4 Window Mechanism AdiustmentBronco and F- ASSEMBLV 21452 WEATHERSTRI ASSEMBLY 21436 ( CHANNEL ASSEMBLY 21458 N247l-ZC Series Truck 4. Position the vent window and the front run retainer 2. Remove the screw from the front run retainer (Fig. and division bar in the door. Then, insert the front 2, View A). 52::itlgzlcgiizmon bar m the rear edge Of the 3. Remove three vent window assembly attaching f t t . 5. Position the rear run retainer to the door, and install screws rom he ront edge Of the door the two attaching screws. 4. Lower the door glass and pull the glass run out of 6. Position the glass and channel assembly in the front the upper run retatner near the vent wtndow run retatner and dtvmon bar and the rear run dw's'orl bar only enough _to allow removal Of the Then, place the vent wtndow assembly into posttlon vent wtndow assembly (Vtew Dl in the door, and install the three vent frame 5. Tilt the vent window and division bar assembly attaching screws. toward the rear of the door and remove the vent 7. Install the belt weatherstrips. wtndow from the d"- 3. Insert the front run in the front run retainer and 6. Rotate the front edge of the glass downward and division bar. lift the glass from the door (View B). 9. Install the screw attaching the front run retainer and 7. Remove the glass from the glass channel with the division bar bracket to the door. tool shown in Fig. 4. 'IO, Adjust the window glass as outlined in Adiustments. _ ll. Install the door trim panel, if so equipped. lnstallatton 1. Install the glass in the glass channel with the tool anouco AND F-IOO THRu F-350 WW" '" 9' 4- . 2. Position the glass and channel assembly tnto the Removal door, inserting the regulator arm roller into the slot 1. Remove the door trim panel. of the glass channel (View B, Fig. 2).