1984 Ford Bronco Rear Bed Floor Replacement Panel - Hand-Drawn Dimensions

This is a hand-drawn dimensional sketch (blueprint) on graph paper for fabricating a replacement rear bed / cargo floor panel for a 1984 Ford Bronco. Notes state the original panel was 20 gauge ribbed steel and that the owner intends to replace it with thicker sheet stock without ribs. A cost note indicates a 50 x 50 inch sheet costs $65, plus charges for cutting, brake (bending), and shipping. The main drawing shows a roughly rectangular panel 49 inches wide (marked "Very critical") by 52 inches tall (marked "not as critical"), with a center rectangular cutout measuring 6.5" x 4" located 34" up from the bottom edge and 24.5" from the right edge. Two smaller oval holes sit 24" up from the bottom, one 7.5" from the left edge, the other about 7"/1.5" dimensioned on the right side. Paired mounting holes are shown 1.5" in from each top corner and 6" down from the top edge. A second sketch below shows the edge/flange profile: the 49" wide panel with 0.75" bent-up flanges on each side. A reader can use this document to reproduce the cut and bend dimensions for a replacement Bronco rear bed floor panel.