Service Procedures: Ford Probe 1993-1997

Technical Reference

Member-uploaded diagrams & documents for this generation. AI-classified; community-verified where badged.

Service Procedures

• 1995 Probe service manual pages (August 1994) showing manual transaxle assembly steps for the shift lever shaft, shift gate and reverse lever.
• 1993 Ford Probe Two Speed Cooling Fan Circuit Operation - 2.0L & 2.5L
  This document is a 'How The Circuit Works' description for the Two Speed Cooling Fan circuit, applicable to vehicles with 2.0L and 2.5L engines (consistent with the uploader's Ford Probe). It explains that battery…
• Test procedure for the pick-up coil (signal generator), 130-190 ohms across Red and White wires, and the ignitor module using a flashlight battery and ohmmeter.
• Ford Probe Control Module Bench Test Diagram - Ohmmeter & Test Light Hookup
  This document is a labeled illustration showing a bench-test setup for a control module. The diagram depicts a control module connected to a 12 volt battery, a test light, and an ohmmeter. Callout labels identify the…
• Owner's manual page covering HomeLink training steps 5-8, a note for Canadian owners and how to spot a rolling code garage door opener.
• Ford T92C-6000-AH Breakout Box Adapter Instructions - 1993 Probe 2.0L & 2.5L
  This document is an instruction sheet for the Ford T92C-6000-AH Breakout Box Adapter, stated as applicable to 1993 Probe 2.0L and 2.5L engines. It explains how to connect the adapter between the vehicle wiring harness…
• Turbosmart Boost Tee Instructions - Gate System Removal & Troubleshooting
  This document is page 3 of 4 of a Turbosmart Boost Tee manual boost controller instruction sheet (PDF filename INST_BoostTee[1].pdf, viewed in Adobe Reader). The visible section, titled 'Important Notes on Gate System…
• Instructions giving rod bearing clearance 0.002-0.003", small end 0.0009-0.0015" floating or 0.0006-0.0009", side clearance 0.015-0.025".
• Pressure regulator valve spring inspection showing a caliper measuring free length, specified at 46.79mm (1.842 inches); replace the spring if out of spec.
• Owner's manual steps for training a HomeLink Universal Transceiver button to a garage door opener remote, including erasing old codes first.
• Printed "Removal 101" checklist with step-by-step draining of fluids and removal of the radiator, battery tray, sensors and engine wire harness.
• ARP stud kit head installation procedure showing right and left head gasket identification marks, with a head stud and packet of ARP moly assembly lubricant.