Owner's manual page with HomeLink transceiver training steps 5 t…

Canadian Owners: ' . The remote control you are training from may stop transmitting after two ' ' for conds. This is not long enough IfomeLink to learn the code. Release and press the button on the remote control every two seconds until HomeLink has learned the code. 5. The red light in HomeLink should be n ashing. It will ash slowly at rst, then rapidly. 6. When the red light flashes rapidly, release both buttons. HomeLink should have learned the code from the remote control. 7. Plug in the garage door opener :notor. then ttest the HomeLink ransceiver utton by pushin it. It should operate the garage do%r. If the button does not work. repeat this procedure to train it again. If it still does not work, you may have a door opener. Test this by prisi and holding the HomeLink m) . transceiver button you just tr . If the red light blinks for twodlm d seconds. then stays on. you have a rolling code garage door opener, You may be able to verify this with the manufacturers documentation. Go to Training With a Rolling Code System." ' . Repeat these steps to train the other two HomeLink buttons to operate any other remotely controlled devices around your home (lighting, automatic gate. security system, etc).