13-064 T Steering ColumnShift Rod Within Tube 13-06-1 l REMOVE cups TO RELEASE WIRE BALE WIRE BALE SPRING RELEASE spews AND CAP ___ SPRING .}.ij-ix?~ Mix 2)va ELAgiGE ASSEMBLY LOCK'NG LEVER ' 616892 no. to Wire Bale and rm Locking Lever 7. Remove the flanges, steering shaft and wiring harness. 8. Remove the upper and lower bearings in the upper tilt flange as outlined in this Part. Assembly i. Assemble the upper and lower bearings in the upper tilt flange as outlined in this part. 2. Install the upper and lower flanges, steering shaft and wiring harness. 3. Assemble the upper and lower castings by installing the two pivot pins using a C-clamp as shown in Fig. 12. Do not re-use pivot pins if press fit is loose in the flanges. insure that the spring is properly seated between the upper and ower ti anges. 4. install the steering column upper snap ring. 5. install the locking lever and spring. insert the dowel pm thacti holds'the 1 locking lever. A C-clamp may e use to re ieve the tension on th ' ' assembly (Fig. 11). e pm during 6. Install the small 5 ' ' _ pring and ca assembl upper tilt flange. p y m the 7. Position the wire bale on the upper flange casting and install the two spring clips that hold the wire bale in place. UPPER AND lOWER BEARINGS TILT COLUMN UPPER FLANGE Dieessembly 1. Remove the tilt mechanism as outlined in this Part. 2. Place the flange casting on a bench with the sma\ 3, bearing facing down. 3. With a small pick, lightly tap on the outer race - . the small bearingat each slot. Never drive or apply _ pressure of any kind to the inner race of the bearing. 4. invert the flange casting and place it on a bench with the large bearing facing down. 5. With a small pick, lightly tap on the outer race of the large bearing at each slot. Never drive or apply FLANGE ASSEMBLY TOO L T70P30739. A TOOL T67P-3D739~8 lSCREw ONLY) 62823411 FIG. I] Removing Pivot Pin