To make draining easier & cleaner, I cut a hole in the bottom of the beam below the lowest point of the 3rd member housing. Since I'm using an older chunk, the casting doesn't have a flat surface behind the axle arm's lip. Later castings do, so this step wouldn't be necessary.
SEE THE NEXT FEW PICS...
![24beamhole.jpg To make draining easier & cleaner, I cut a hole in the bottom of the beam below the lowest point of the 3rd member housing. Since I'm using an older chunk, the casting doesn't have a flat surface behind the axle arm's lip. Later castings do, so this step wouldn't be necessary.
[url=https://www.supermotors.net/registry/media/849741][img]https://www.supermotors.net/getfile/849741/thumbnail/drainplugsmag.jpg[/img][/url]
SEE THE NEXT FEW PICS...](https://www.supermotors.net/getfile/766016/fullsize/24beamhole.jpg)