Hyundai Genesis Coupe 2.0T Engine Room Connector & Relay Locations (G4KF)
Service manual component-location page showing labeled relays, sensors and connectors across engine room, trunk and wheel housing views.
This document is a component location reference page (likely from a Hyundai shop manual) showing six labeled photographs of connector, relay, and sensor locations. Panel 7 shows the right front wheel housing with the front wheel speed sensor RH connector E36 (2-pin black). Panel 8 shows the right side of the trunk room with rear combination lamp RH connector F58 (6-pin white). Panel 9 shows the left side of the engine room with the E45 multipurpose check connector (20-pin black), E60 horn relay, E50 vacuum pump relay (G4KF engine with A/T), E65 front wiper relay, and joint connectors JE67, JE68, JE70, and JE71. Panel 10 shows the left side of the engine room relay box with the E62 rear heated (RR HTD) relay, E53 IG1 relay, E57 dedicated DRL relay, E61 start relay, E55 ACC relay, E63 front deicer relay, and E54 IG2 relay. Panel 11 (G4KF engine) shows ECM connectors CHG-A (60-pin) and CHG-K (94-pin), TCM connector CHG-T (94-pin), CHG45 brake fluid level sensor, E29 hood switch, joint connector JCH01, and grounds GHG01 and GHG03. Panel 12 (G4KF) shows CHG22 ETC motor & throttle position sensor, CHG05-1 oil control valve #1, CHG03 oil temperature sensor, and CHG26 boost pressure sensor connectors.
Is this accurate? Sign in to help verify it.
Frequently asked questions
- Where is the dedicated DRL relay located?
- The E57 dedicated DRL relay is in the relay box on the left side of the engine room, near the E53 IG1 relay, E55 ACC relay, E61 start relay, E62 RR HTD relay, E63 front deicer relay, and E54 IG2 relay.
- What connector is the right front wheel speed sensor?
- The right front wheel sensor connector is E36, a 2-pin black connector located in the right front wheel housing (photographed with the right front wheel guide removed).
- Where are the ECM and TCM connectors on the G4KF engine?
- At the left rear of the engine room: CHG-A ECM (60-pin black), CHG-K ECM (94-pin black), and CHG-T TCM (94-pin black).
- What is connector CHG26?
- CHG26 is the boost pressure sensor connector, a 4-pin black connector located at the left front of the engine (G4KF engine).
- Where is the E50 vacuum pump relay used?
- The E50 vacuum pump relay applies to the G4KF engine with automatic transmission (A/T) and is located on the left side of the engine room near the horn relay E60.
Comments
More from this build
No comments yet.