Home/ Registry/ Ford/ Bronco/ 1980-1986/ “The Mall-Crawler”/ Photo supermotors.net/registry/media/135519

Engine bay close-up with spark plug wires, split-loom harness an…

‹ ›

EFIView all 12

Engine bay close-up of throttle body, wiring looms and vacuum lines

Red truck interior dash with woodgrain trim and aftermarket stereo

Rusty four-port tubular cast iron exhaust manifold with O2 sensor bung on tile floor

Rubber air intake tube with red measurement callouts and heater hose vent label

Black plastic automotive part on concrete floor with wires and leaves

Corroded starter solenoid on inner fender with red battery cables and heat-shrink terminals

Aluminum lower intake manifold with six runner ports and labeled sensor locations

Ford Motorsport Multiport EFI harness manual page 1 with table of contents

Edelbrock Performer 5.8 lower intake manifold with labeled EGR passage, injector bosses, PCV and sensor ports

Edelbrock Performer 5.8 lower intake manifold with labeled ports and sensors

Six intake manifold gaskets shown in a grid layout, labeled GT-40, 5.0L Car, Trick Flow, Edelbrock, 5.0L Truck

12photos in this albumView all

Close-up inside an engine bay showing a cast-aluminum bracket, black-jacketed spark plug wires with heat boots, and a corrugated split-loom harness routed past a bare metal component secured with a hose clamp. An orange-handled tool and a coiled spring rest across the top of the frame, with surface rust on the adjacent sheet-metal bracket.

AI caption July 2004 · Photo 102 of 940