Home/ Registry/ Ford/ Bronco/ 1980-1986/ “The Mall-Crawler”/ Photo supermotors.net/registry/media/244351

Rubber air intake tube with red measurement callouts and heater…

‹ ›

EFIView all 12

Engine bay close-up of throttle body, wiring looms and vacuum lines

Engine bay close-up with spark plug wires, split-loom harness and hose-clamped tube

Red truck interior dash with woodgrain trim and aftermarket stereo

Rusty four-port tubular cast iron exhaust manifold with O2 sensor bung on tile floor

Black plastic automotive part on concrete floor with wires and leaves

Corroded starter solenoid on inner fender with red battery cables and heat-shrink terminals

Aluminum lower intake manifold with six runner ports and labeled sensor locations

Ford Motorsport Multiport EFI harness manual page 1 with table of contents

Edelbrock Performer 5.8 lower intake manifold with labeled EGR passage, injector bosses, PCV and sensor ports

Edelbrock Performer 5.8 lower intake manifold with labeled ports and sensors

Six intake manifold gaskets shown in a grid layout, labeled GT-40, 5.0L Car, Trick Flow, Edelbrock, 5.0L Truck

12photos in this albumView all

Annotated reference photo of a rubber air intake tube assembly with a bellows section and twin outlet branches, laid on gray carpet. Red dimension callouts label the 3-1/8 inch inlet, 2-3/4 inch and 2 inch sections and 2-3/8 inch branches, with green text pointing out the 1/2 inch heater hose to the oil filler vent tube.

AI caption September 2005 · Photo 206 of 940