Home/ Registry/ Ford/ Bronco/ 1980-1986/ “The Mall-Crawler”/ Photo supermotors.net/registry/media/260727

Corroded starter solenoid on inner fender with red battery cable…

‹ ›

EFIView all 12

Engine bay close-up of throttle body, wiring looms and vacuum lines

Engine bay close-up with spark plug wires, split-loom harness and hose-clamped tube

Red truck interior dash with woodgrain trim and aftermarket stereo

Rusty four-port tubular cast iron exhaust manifold with O2 sensor bung on tile floor

Rubber air intake tube with red measurement callouts and heater hose vent label

Black plastic automotive part on concrete floor with wires and leaves

Aluminum lower intake manifold with six runner ports and labeled sensor locations

Ford Motorsport Multiport EFI harness manual page 1 with table of contents

Edelbrock Performer 5.8 lower intake manifold with labeled EGR passage, injector bosses, PCV and sensor ports

Edelbrock Performer 5.8 lower intake manifold with labeled ports and sensors

Six intake manifold gaskets shown in a grid layout, labeled GT-40, 5.0L Car, Trick Flow, Edelbrock, 5.0L Truck

12photos in this albumView all

Close-up of a starter solenoid mounted to the inner fender of a truck engine bay, with heavily corroded copper terminals and mixed red battery cables, some with fresh red heat-shrink boots and others with bare crimped ends. A black frame rail and a barcode sticker on a battery are visible below.

AI caption November 2005 · Photo 225 of 940