Home/ Registry/ Ford/ Bronco/ 1980-1986/ “The Mall-Crawler”/ Photo supermotors.net/registry/media/554927

Edelbrock Performer 5.8 lower intake manifold with labeled ports…

‹ ›

EFIView all 12

Engine bay close-up of throttle body, wiring looms and vacuum lines

Engine bay close-up with spark plug wires, split-loom harness and hose-clamped tube

Red truck interior dash with woodgrain trim and aftermarket stereo

Rusty four-port tubular cast iron exhaust manifold with O2 sensor bung on tile floor

Rubber air intake tube with red measurement callouts and heater hose vent label

Black plastic automotive part on concrete floor with wires and leaves

Corroded starter solenoid on inner fender with red battery cables and heat-shrink terminals

Aluminum lower intake manifold with six runner ports and labeled sensor locations

Ford Motorsport Multiport EFI harness manual page 1 with table of contents

Edelbrock Performer 5.8 lower intake manifold with labeled EGR passage, injector bosses, PCV and sensor ports

Six intake manifold gaskets shown in a grid layout, labeled GT-40, 5.0L Car, Trick Flow, Edelbrock, 5.0L Truck

12photos in this albumView all

Overhead view of an Edelbrock Performer 5.8 lower intake manifold in raw aluminum, labeled with callouts for EGR passage, ECT, injector bosses, PCV, intake runners, ACT sensor, and temp gauge sending unit.

AI caption August 2007 · Photo 515 of 940

EDEUJEERCK PERFRMER 5.8 [LQWER EGR passage 7 (exhaust gas reurculation] INJECTOR Boss (TYP a) EGT Engine pcv Cooont / Positive Temp Crunkcuss Ventuhon ~ INTAKE RUNNERS TEMP GAUGE (WP B) SENDING UNIT# Gucknnr ACT (Air Charge Temp sensor)

Is this accurate? Sign in to help verify it.