1991 Ford Crown Victoria Floorpan Reinforcement Sketch - Boxed with Angle Iron

This document is a hand-drawn sketch, not a factory schematic. It depicts a vehicle floorpan as seen from the rear of the vehicle, showing two front seats (with headrests) mounted on the floorpan. The floorpan profile between and around the seats is drawn as a wavy cross-section, with a raised hump between the two seats. Two arrows point to the area of the floorpan between/under the seats, labeled 'HERE', indicating the specific location the author wants to highlight. The handwritten caption at the bottom reads 'FLOORPAN VIEWED FROM REAR, BOXED W/ANGLE IRON', meaning the indicated section of the floorpan has been (or is intended to be) reinforced/boxed using angle iron. A portion of the floorpan outline on the right side is drawn with a heavier line, likely representing the boxed/reinforced section. The sketch contains no part numbers, dimensions, torque specs, wire colors, or year/model identification. It was uploaded to a 1991 Ford Crown Victoria gallery, so it presumably illustrates a floorpan reinforcement modification on that car, but the drawing itself does not state any vehicle applicability.