Rock Slider Blueprint Sketch - Tube Profile & Rail Mounting Tab Layout Drawing

This document is an untitled, undimensioned line drawing (blueprint sketch) apparently depicting a rock slider / nerf bar design, consistent with the upload filename 'dodge-ram-sliders.JPG'. The upper portion shows a cross-section or end/profile view: a round tube joined to a rounded rectangular (square tube) member, with angled support gussets or legs running back to a vertical flat mounting plate. A purple/blue contour line traces what appears to be the vehicle body or rocker panel profile above the slider, showing how the assembly tucks under the body line. The lower portion shows a side elevation of the full slider rail: a long horizontal bar with small rectangular mounting tabs or brackets spaced along its length and end caps or plates at each end. No text, dimensions, part numbers, torque values, or material callouts are present anywhere in the drawing, so a reader can learn only the general geometry and mounting concept of the slider, not specific measurements. The drawing pairs with a companion scan in the same album (frame-mount.JPG), suggesting it is one page of a homemade rock slider fabrication plan filed under a 1978 Ford Bronco.