1979 Ford Bronco Custom Bumper Blueprint - 74.5 in Fabrication Drawing

This document is a simple CAD-style blueprint (line drawing) of a long, flat bumper, consistent with a custom front or rear bumper design for a vehicle, uploaded to a 1979 Ford Bronco gallery with the filename "bmbmprRAFS.jpg". It contains three views: a top/edge view of the bar showing a thickness or height of 3 units; a main front elevation showing an overall length of 74.5 units, an end height of 6 units with a 2-unit taper, and an 18-unit tapered section at each end; and a small end/cross-section detail dimensioned 2.5 by 2.5 units. The main view also shows two narrow vertical slots and a central rectangular opening (possibly for a license plate light, winch fairlead, or receiver), though these features are not dimensioned. No units, material callouts, part numbers, title block, vehicle applicability, or notes appear anywhere on the drawing. Dimensions are most plausibly in inches (74.5" overall length is typical of a full-size Bronco bumper). A fabricator could use this sheet to lay out the overall envelope of the bumper, but would need additional information for slot locations, hole sizes, and material thickness beyond what is dimensioned here.