1993 Ford Bronco/F-150 V8 5.0 Serpentine Belt Routing Diagram & Tensioner

This document is a factory-style schematic showing the 1993 V8 serpentine (accessory drive) belt routing. The upper diagram illustrates the path of the single serpentine belt around eight pulleys, each labeled with a callout: alternator, idler, automatic belt tensioner, air conditioner compressor, water pump, power steering pump, air pump, and crankshaft. This lets a reader see exactly how to route a new belt after replacement. The lower diagram shows an exploded view of the automatic belt tensioner assembly and its mounting bolt, with an instruction to tighten the bolt to the specs listed below (the actual torque specification is not shown on this page). An important installation note states that the locating pin must be in the bracket hole prior to tightening the tensioner mounting bolt. Diagram reference codes Q2601-E and Q2765-D appear on the two illustrations. The document identifies itself as covering the 1993 V8 engine; no make or model name is printed on the page, though it was uploaded to a 1992 Ford Bronco gallery. Useful for anyone replacing or re-routing a serpentine belt or installing a belt tensioner on this engine.