SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Join
Home/ Registry/ Ford/ Bronco/ 1980–1986/ “That dirty old truck”/ '84-89 Fuel Reservoirs supermotors.net/registry/2742/66025

Album section

'84-89 Fuel Reservoirs

From 1983 Ford Bronco “That dirty old truck” — documented by Steve83.

37 photos
← Back to this vehicle
1983 Ford Bronco - '85-89 Fuel Systems IF THE IMAGE IS TOO SMALL, click it. For Type 2 SFR, read this page & the NEXT several: [url=https://www.supermotors.ne… 1983 Ford Bronco - Single-Function Reservoir Installation IF THE IMAGE IS TOO SMALL, click it. NOTE: The frame mounted fuel filter was repositioned to between… 1983 Ford Bronco - Hi-Pressure Fuel Pump, Filter, & Dual-Function Reservoir F1UZ-9B263-B for '84-89 EFI IF THE IMAGE IS TOO SMALL, click it. [url=http://www.s… 1983 Ford Bronco - Early High-Pressure Fuel Pump & Filter IF THE IMAGE IS TOO SMALL, click it. [url=https://www.supermotors.net/registry/media/1169342] https:… 1983 Ford Bronco - '85 5.0L In-Tank (Low-Pressure) Fuel Pump, Level Sender, & Tank Plate (Tank Hanger Assembly) IF THE IMAGE IS TOO SMALL, click it. [url=http… 1983 Ford Bronco - Low-Pressure In-Tank Fuel Pump for '84-89 EFIs The large (~3") mounting plate shown is for '88-89 IF THE IMAGE IS TOO SMALL, click it.… 1983 Ford Bronco - Plastic Fuel Line Clips IF THE IMAGE IS TOO SMALL, click it. Do not use silicone grease anywhere near the fuel system. 1983 Ford Bronco - '86 F-series Fuel Tanks IF THE IMAGE IS TOO SMALL, click it. For wheelbase, see this: [url=http://www.supermotors.net/registry/media/72354]… 1983 Ford Bronco - '88 Single-Function Reservoir Used on '88-89 Broncos & F-series/E-series/Rangers/others with single tank dual-pump EFI. In this version, th… 1983 Ford Bronco - '86-87 Single-Function Reservoir (SFR) Fuel Flow IF THE IMAGE IS TOO SMALL, click it. Fuel flows in through the larger tank-side supply nip… 1983 Ford Bronco - '88-91 Single-Function Reservoir (SFR) Fuel Flow IF THE IMAGE IS TOO SMALL, click it. Fuel flows in through the larger tank-side supply nip… 1983 Ford Bronco - Dual-Function Reservoir F1UZ-9B263-B IF THE IMAGE IS TOO SMALL, click it. If available, priced from $90-300 plus sh Ford F1UZ-9B263-B , [ur… 1983 Ford Bronco - Dual-Function Reservoir F1UZ-9B263-B If available, priced from $90-300 plus sh Ford F1UZ-9B263-B , [url=https://www.rockauto.com/en/moreinf… 1983 Ford Bronco - Dual-Function Reservoir Assembled (replaced by F1UZ-9B263-B ) After thoroughly cleaning the outside of the reservoir assembly and loosening… 1983 Ford Bronco - Dual Function Reservoir Cover Remove the 8 screws from the diaphragm cover & lift it off carefully. Do not distort the orange diaphragm or… 1983 Ford Bronco - Dual Function Reservoir Diaphragm Without distorting the diaphragm, remove the phillips screw from the diaphragm top plate & lift them off… 1983 Ford Bronco - Dual Function Reservoir Plate Using needle-nose pliers, push the valve pushrods out of the clips in the bottom plate (by rotating the plate… 1983 Ford Bronco - Dual Function Reservoir O-ring Without distorting it, remove the tiny O-ring from the edge of the body. Re-install the phillips screw by ha… 1983 Ford Bronco - The main cause for the valve NOT to switch is the tiny O-ring that allows fuel to the top of the diaphragm swelling shut (because of ethano… 1983 Ford Bronco - Dual Function Reservoir Detent Using the screw as a handle, pull the detent rod out. 1983 Ford Bronco - Dual Function Reservoir Rings Using a clean, sharp pick, carefully pry each tab of the lock rings up one-at-a-time working slowly around ea… 1983 Ford Bronco - Dual Function Reservoir Switching Valve Noting their orientations, extract each valve from its bore. If they remain, carefully remove the w… 1983 Ford Bronco - Dual Function Reservoir Switching Valve IF THE IMAGE IS TOO SMALL, click it. Without distorting any rubber parts, slide each component off… 1983 Ford Bronco - Dual Function Reservoir Exploded F1UZ-9B263-B $90-200 plus sh IF THE IMAGE IS TOO SMALL, click it. Thoroughly clean & inspect each part. Re… 1983 Ford Bronco - Dual Function Reservoir Check Valve The check valves are glued into the reservoir body and should not be removed. If the supply check valve… 1983 Ford Bronco - I could tell these O-rings were swollen when I rebuilt this DFR, but I didn't realize they would blow off the valves while I was test-drivi… 1983 Ford Bronco - Dual Function Reservoir Check Valve WIth the supply switching valve removed, a bent probe can be used to push the check valve out far enoug… 1983 Ford Bronco - Dual-Function Reservoir (DFR) F1UZ-9B263-B Fuel Flow - Top Tank Ports When the tank connected to the top ports is selected by the dash swit… 1983 Ford Bronco - Dual-Function Reservoir (DFR) F1UZ-9B263-B Fuel Flow - Bottom Tank Ports When the tank connected to the bottom ports is selected by the das… 1983 Ford Bronco - Dual-Function Reservoir Installation IF THE IMAGE IS TOO SMALL, click it. NOTE: The frame mounted fuel filter was repositioned to between t… 1983 Ford Bronco - '84-89 Dual-Function Reservoir IF THE IMAGE IS TOO SMALL, click it. The engine supply line feeds the high-pressure frame-mounted fuel pump,… 1983 Ford Bronco - '84-86 5.0L Fuel Pump & Filter under driver's floorboard (A5/FU) IF THE IMAGE IS TOO SMALL, click it. [url=http://www.supermotors.net/regis… 1983 Ford Bronco - Reservoir This is a dual-function reservoir F1UZ-9B263-B from an '88 F150, but 2 ports are blocked off and only one tank is connected. A re… 1983 Ford Bronco - Eventually, I realized that the problem with the DFR was the aftermarket solenoid-style fuel pumps. Because they didn't allow fuel to bleed… 1983 Ford Bronco - '88 Inertia Switch Location firewall forward of the e-brake & clutch pedals B5FO on this chart: [url=http://www.supermotors.net/registry/me… 1983 Ford Bronco - SOLD Rear tank for EFI pickups. Low-pressure in-tank pump ('84-89 EFI) available. Clean, dry; no rust, dents, or leaks. 1983 Ford Bronco - '87 EFI Small-hole Fuel Tank Connections