STV Motorsports 5-Pin LED Rocker Switch Wiring Diagram & Instructions

This document is an instruction sheet from STV Motorsports for wiring their LED-illuminated rocker switches, photographed with the actual switch resting on top of the sheet. A prominent warning states not to reverse the (+) and (-) terminals (which damages the LED and voids the warranty) and not to exceed a 20 AMP load on the switch; support contact info is given ([email protected], (702) 701-7101). The switch body is marked 12V 20A DC / 24V 10A DC with a CE mark. The main portion covers the 5-PIN switch configuration, with a rear-view pin diagram (pins 1-8 positions shown) and per-pin instructions: PIN 8 to (-) ground (upper switch light), PIN 7 to (-) ground jumped to PIN 8 (lower switch light), PIN 6 to ignition (keyed-on power), PIN 3 to relay/accessory, and PIN 2 from a (+) power source with an inline fuse. Two small ON-OFF schematic diagrams (labeled A3 and A6) illustrate the internal circuit and lighting behavior (2=3 when on, 'No Electricity' when off). This is a generic accessory switch document, not vehicle-specific, so it applies to any 12V/24V installation including the uploader's 2015 Ford F-550.