STV Motorsports 5-Pin LED Rocker Switch Wiring Diagram & Instructions 12V/24V

This document is an instruction sheet from STV Motorsports for wiring an illuminated LED rocker switch, photographed with the actual switch lying on top of the sheet. A prominent warning states not to reverse the (+) and (-) terminals (which damages the LED bulb and voids the warranty) and not to exceed a 20 AMP load on the switch; support contact info is [email protected] or (702) 701-7101. The switch body itself is marked STV, CE, and rated 12V 20A DC / 24V 10A DC. The visible portion covers the 5-PIN wiring configuration: PIN 8 connects to (-) ground for the upper switch light; PIN 7 connects to (-) ground and jumps to PIN 8 for the lower switch light; PIN 6 connects to ignition (keyed-on power); PIN 3 connects to the relay/accessory; and PIN 2 connects to a (+) power source with an inline fuse. Two schematic diagrams (labeled A3 and A6) show ON-OFF operation, indicating that positions 2 and 3 close the circuit ('2=3') versus 'No Electricity' in the off state, with lighting terminals 7(-), 8(-), and 6(+). This is a generic switch instruction sheet, not a vehicle-specific wiring diagram.