SuperMotors SuperMotors SUPERMOTORS Search — try “orange Bronco on 35s”
Home/ Registry/ Hyundai/ Genesis/ “Coupe”/ Photo supermotors.net/registry/media/1139727

2010 Hyundai Genesis Coupe Connector MR01 Location - Driver A-Pillar Photo

Service procedure photo locating connector MR01 along the A-pillar trim above the steering wheel.

AI caption · Photo 846 of 981

This document is a service manual reference photograph labeled "PHOTO.47" showing the location of connector MR01 in a vehicle's interior. The photo is taken from inside the cabin looking at the driver-side A-pillar with the pillar trim removed, exposing the wiring harness that runs down the pillar. A callout box labeled "MR01" with an arrow identifies the connector's location at the lower end of the A-pillar where it meets the top corner of the dashboard, adjacent to the windshield edge. The steering wheel, turn signal stalk, and part of the instrument cluster (tachometer/speedometer gauges) are visible in the frame, confirming this is the driver's side. The uploader filed this as a connector location photo for a 2010 Hyundai Genesis (Coupe, based on the surrounding album of Genesis Coupe wiring diagrams). A reader can use this photo to locate connector MR01 when performing electrical diagnosis or harness repair, as connector location photos like this typically accompany wiring diagrams that reference the connector by its code. The document itself contains no year, model, part number, torque, or wiring color information — only the photo number and connector designation.

Is this accurate? Sign in to help verify it.

Frequently asked questions

Where is connector MR01 located?
According to PHOTO.47, connector MR01 is located at the base of the driver-side A-pillar, behind the pillar trim near the top corner of the dashboard by the windshield edge.
What does PHOTO.47 show?
It shows the interior driver-side A-pillar with trim removed, exposing the wiring harness, with an arrow identifying the location of connector MR01.
Do I need to remove trim to access connector MR01?
The photo shows the A-pillar trim removed to expose the harness and connector, indicating the pillar trim must be removed to access MR01.

Comments

No comments yet.

More from this build

Cooling-fan wiring diagram for Theta 2.0 TCI engine with fan relays, fuses and coolant sensor Cooling System wiring diagram for Lambda II 3.8 GDI engine with fan relays, fuses and sensor Service photo labeling instrument-panel wiring connectors I/P-A to I/P-K and Z01 diode Wiring diagram legend of wire color codes, harness and connector identification Service manual figure Photo.59 with callouts to PDM modules and rear parking assist buzzer Service manual figure labeling BCM connectors, in-car temp sensor and TPMS module Close-up of Hyundai Genesis coupe engine bay showing intake manifold, sensors, hoses, and a yellow wire. Starting system wiring diagram with battery, start relays, solenoid and motor, ignition switch and color-coded wires

More Hyundai Genesiss