1995 MLP/TR sensor connector swap wire splice steps 4-5 with hea…

WIRE SPLICE SOLDERING INSTRUCTIONS (Contd) 4. Reposition heat shrink tubing over splice. WIRE #2 HEAT SHRINK TUBING 5. Heat the entire length of the heat shrink tubing until the hot melt wax appears from both ends of the tubing. NOTE: Durability of a heat shrink tubing splice is dependent on the hot melt wax that will appear from both ends of the tube. The hot melt wax forms an adhesive seal between the wire insulation and the heat shrink tubing, which prevents air and moisture from entering the solder point. HOT MELT WAX HEAT SHRINK TUBING WARNING: USE HEAT GUN ONLY. DO NOT USE HAIR DRYER OR FLAME TO HEAT THE SHRINK TUBING. SHEET 6 OF 6 LS. 6628A 1995 MLP/TR SENSOR CONNECTOR emoggggglg 333$? ASSEMBLY SWAP INSTRUCTIONS 11-96