What fuse powers the horn circuit in this diagram?

Fuse position 14 in the fuse box, rated at 15A, supplies the horn circuit via a green (G) wire.

What are the wire colors in the horn circuit?

Green (G) from the fuse box to the relay, Blue/Green (Bl/G) from relay pin 3 to the horn switch, Green/Black (G/B) from relay pin 4 to both horns, and Black (B) from the horns to ground.

What connector is the horn relay on?

The horn relay uses connector E58, with pins 1 and 2 receiving power, pin 3 going to the horn switch, and pin 4 feeding the horns.

What connectors are used for the left and right horns?

The left horn (LH) uses connectors E01 (pin 1, input) and E02 (pin 1, output); the right horn (RH) uses E05 (pin 1) and E06 (pin 1).

How does the horn switch complete the circuit?

The horn switch (connector E40, pin 4) receives the Blue/Green wire from relay pin 3 and switches it to ground, energizing the relay coil so the relay powers the horns.

Home/ Registry/ Suzuki/ Samurai/ 1986-1995/ “Little Blue”/ Photo supermotors.net/registry/media/420668

Suzuki Samurai Horn Wiring Diagram - Relay, Switch & Fuse Circuit

Wiring diagram: horn relay, horn switch and LH and RH horns fed from the fuse box

‹ ›

Reference · 1986-1995 SamuraiAll 73 wiring diagrams

Suzuki Samurai A/C Amplifier & Heater Illumination Wiring Diagram (HVAC)

Suzuki HVAC Wiring Diagram - Blower Motor, Blower Switch & A/C Circuit

Suzuki Samurai A/C Wiring Diagram - Compressor, Condenser Fan Relay & Amplifier

Suzuki Samurai Horn Wiring Diagram - Relay, Switch & Fuse Circuit

Suzuki Samurai Headlight & DRL Control Unit Wiring Diagram - Fuses, Switches

Suzuki Samurai Headlamp Wiring Diagram - Fuses 11/12 15A, Dimmer & Lighting Switch

Suzuki Turn Signal & Hazard Warning Wiring Diagram - Flasher Relay Circuit

Suzuki Turn Signal & Hazard Flasher Wiring Diagram - Fuses, Relay, Wire Colors

Suzuki Samurai 8v EFI Swap ECM Connector C2 Pinout - Wire Colors & Circuits

Suzuki Sidekick/Geo Tracker 8v EFI Swap into Samurai - ECM C1 Pinout & Wiring

73wiring diagrams1986-1995 Suzuki Samurai More reference

Schematic

1986 Suzuki Samurai Fuse Box Diagram - Main Fuse Block & Fuse Panel Layout

Fuse chart

Tatou 4S ATV Track System Rear Frame Dimensions & Specs Diagram

Brochure

Suzuki Samurai 8v EFI Swap Wiring - Pin Colors & 8A-20 Diagram Index (Pg 4)

Manual page

Suzuki Samurai Mitsubishi 12V Starter Data Plate - M3T41781 / 31100-83030

Spec plate

Vacuum routing

1987 Suzuki Samurai Fabrication Template - Hand-Drawn Full-Size Layout w/ Dims

Blueprint

Photo of Purple Compact Car Front Wheel & Fender (Misfiled Samurai Doc Scan)

Exploded parts

Trail Tough Samurai Twisted T/T shift shaft installation instructions beside bagged shift shafts and gasket

Service procedure

Wiring diagram of the horn circuit showing the horn relay, horn switch and left and right horns.

Part of 1986-1995 Suzuki Samurai Wiring Diagrams

AI caption August 2006 · Photo 37 of 86

This document is a wiring diagram for the horn circuit, uploaded as part of a set of Suzuki Samurai reference scans. It shows power originating at the fuse box, fuse position 14 rated at 15A, feeding a green (G) wire that splits to supply both terminals 1 and 2 of the horn relay (connector E58). Relay terminal 3 exits on a Blue/Green (Bl/G) wire to the horn switch (connector E40, pin 4), which completes the relay coil circuit to ground when pressed. Relay terminal 4 outputs on a Green/Black (G/B) wire that splits to feed both the left horn (connectors E01 pin 1 in, E02 pin 1 out) and the right horn (connectors E05 pin 1 in, E06 pin 1 out). Both horns return on Black (B) wires that join and terminate at a chassis ground marked with the symbol ❶. From this diagram a reader can identify the fuse (14, 15A), relay connector (E58), horn switch connector (E40), horn connectors (E01/E02 LH, E05/E06 RH), and all wire colors used in the horn circuit for troubleshooting a non-working horn.

Is this accurate? Sign in to help verify it.

Frequently asked questions

What fuse powers the horn circuit in this diagram?: Fuse position 14 in the fuse box, rated at 15A, supplies the horn circuit via a green (G) wire.
What are the wire colors in the horn circuit?: Green (G) from the fuse box to the relay, Blue/Green (Bl/G) from relay pin 3 to the horn switch, Green/Black (G/B) from relay pin 4 to both horns, and Black (B) from the horns to ground.
What connector is the horn relay on?: The horn relay uses connector E58, with pins 1 and 2 receiving power, pin 3 going to the horn switch, and pin 4 feeding the horns.
What connectors are used for the left and right horns?: The left horn (LH) uses connectors E01 (pin 1, input) and E02 (pin 1, output); the right horn (RH) uses E05 (pin 1) and E06 (pin 1).
How does the horn switch complete the circuit?: The horn switch (connector E40, pin 4) receives the Blue/Green wire from relay pin 3 and switches it to ground, energizing the relay coil so the relay powers the horns.